NSH5-232UL-3M Omron, NSH5-232UL-3M Datasheet - Page 90

• Manufacturer Part Number: NSH5-232UL-3M
• Description: 3m RS232 Cable For NSH5
• Manufacturer: Omron

Specifications of NSH5-232UL-3M

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Display Specifications
Note
68
General Specifications
Display panel
Backlight
(See note 4.)
Front-panel indicator RUN
NSH5-SQR00B-V2
NSH5-SQG00B-V2
NSH5-SQR10B-V2
NSH5-SQG10B-V2
(1) This is the estimated time until brightness is reduced by half at room temperature and humidity. It is
(2) The brightness cannot be greatly adjusted.
(3) This function does not detect the end of service life. It detects when the backlight is not lit due to a
(4) Contact your nearest OMRON representative to replace the backlight.
(5) There may be some defective pixels in the display. This is not a fault as long as the numbers of de-
only a reference value. The service life will be drastically shortened if the PT is used at low temper-
atures. For example, using the PT at 0 ° C will reduce the service life to approximately 10,000 hours
(reference value).
disconnection or other error. Backlight error detection indicates that all backlights are OFF.
fective light and dark pixels fall within the following standard range.
Model
Display device
Number of dots
Display colors
Effective display area
View angle
Contrast adjustment
Service life
User replacement
Brightness adjustment
Automatic backlight-OFF
function
Backlight error detection
Item
Number of light and dark pixels:
4 or fewer defects the size of 0.2 < (minor axis + major axis)
Color STN LCD (with backlight)
320 horizontal × 240 vertical dots
256 colors (4,096 colors for BMP/JPG images)
115.18 horizontal mm × 86.38 mm vertical (5.7 inches)
Left/right
100 levels
75,000 hours min. (See note 1.)
Not possible.
There are three levels of adjustment by operating the touch panel.
(See note 2.)
Screen-saver function: 1 to 255 min, in units of 1 min, turned
ON/OFF by system memory operation.
Error is detected automatically at startup, and the RUN indicator
flashes green as notification. (See note 3.)
Lit green: PT is operating normally.
Flashing green: The Memory Card transfer has ended normally or
a backlight error was detected immediately after the power was
turned ON.
Lit orange: Immediately after power is turned ON, indicates file
system check in progress, battery low, or disconnected and operat-
ing normally.
Flashing orange: Memory Card transfer in progress.
Lit red: Memory Card transfer has ended abnormally.
±
50
Standard range
°
; down 50
°
; up 45
Specifications
°
≤
0.55 mm (within 1 per 20 mm)
Appendix A