9005A JEWELL / MODUTEC, 9005A Datasheet - Page 13
![MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT](/photos/27/66/276671/4151371_sml.jpg)
9005A
Manufacturer Part Number
9005A
Description
MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT
Manufacturer
JEWELL / MODUTEC
Datasheet
1.9005A.pdf
(25 pages)
Specifications of 9005A
Dmm Type
Handheld
Voltage Measuring Range Dc
1000
Voltage Measuring Range Ac
750
Current Measuring Range Dc
20µA To 10A
Current Measuring Range Ac
200µA To 10A
Lead Free Status / RoHS Status
na
7: MEASUREMENT PROCEDURES
7.1 Using the HOLD feature:
Note: “H” annunciator appears in the LCD when HOLD is activated.
7.2 Auto Power Off:
7.3 DC Voltage Measurement:
7.3.1 Connect the black test lead to the COM jack and the red test lead to the
The meter may not show the presence of dangerous potentials when HOLD
Do not use the meter when the low battery annunciator
If the magnitude of the voltage to be measured is unknown, always start
is activated. For example, if HOLD is applied when the meter is reading
user to believe that no hazard exists, when, in fact, dangerous voltages
This may cause the meter to produce inaccurate readings, and lead the
The 9005-A incorporates a convenient HOLD feature. This feature “freezes”
the reading in the LCD when the HOLD button is pressed. To release the
HOLD, press the HOLD button again.
The 9005-A has Auto Power Off. This power saving feature automatically
turns the meter off 15 to 20 minutes after turning it on...... thereby
extending battery life.
read zero. Failure to observe this precaution may result in damage to
zero, and 120VAC is subsequently applied, the meter will continue to
If the input voltage is higher than 1000VDC (CAT I), 600V DC (CAT II),
by setting the meter to the highest range, and then to lower ranges,
Do not rotate the RANGE switch with the input applied to the meter.
VOLT / OHM / BEEPER / DIODE “V
Use Caution when measuring voltages above 50V DC.
or 300V DC (CAT III), do not attempt to measure!
until a satisfactory reading is obtained.
the meter or injury to the user.
or currents are present.
WARNING!!!
WARNING!!!
WARNING!!!
12
Ω
” jack.
_
+
is displayed.