HI1-0201HS/883 Intersil, HI1-0201HS/883 Datasheet - Page 4

• Manufacturer Part Number: HI1-0201HS/883
• Description: Analog Switch Quad SPST 16-Pin CDIP
• Manufacturer: Intersil
• Type: Analog Switchr

Specifications of HI1-0201HS/883

• Package: 16CDIP
• Maximum On Resistance: 50@±15V Ohm
• Maximum High Level Output Current: 25 mA
• Maximum Turn-on Time: 50@±15V ns
• Switch Architecture: SPST
• Power Supply Type: Dual

DSCC FORM 2234
APR 97
this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed in the issue
of the Department of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation.
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific
exemption has been obtained.
MIL-PRF-38535 and as specified herein or as modified in the device manufacturer's Quality Management (QM) plan. The
modification in the QM plan shall not affect the form, fit, or function as described herein. The individual item requirements for device
class M shall be in accordance with MIL-PRF-38535, appendix A for non-JAN class level B devices and as specified herein.
MIL-PRF-38535 and herein for device classes Q and V or MIL-PRF-38535, appendix A and herein for device class M.
performance characteristics and postirradiation parameter limits are as specified in table I and shall apply over the full ambient
operating temperature range.
for each subgroup are defined in table I.
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part of
SPECIFICATION
STANDARDS
HANDBOOKS
(Unless otherwise indicated, copies of the specification, standards, and handbooks are available from the Standardization
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text of
3. REQUIREMENTS
3.1 Item requirements. The individual item requirements for device classes Q and V shall be in accordance with
3.2 Design, construction, and physical dimensions. The design, construction, and physical dimensions shall be as specified in
3.2.1 Case outlines. The case outlines shall be in accordance with 1.2.4 herein.
3.2.2 Terminal connections. The terminal connections shall be as specified on figure 1.
3.2.3 Functional diagram. The functional diagram shall be as specified on figure 2.
3.3 Electrical performance characteristics and postirradiation parameter limits. Unless otherwise specified herein, the electrical
3.4 Electrical test requirements. The electrical test requirements shall be the subgroups specified in table IIA. The electrical tests
DEPARTMENT OF DEFENSE
DEPARTMENT OF DEFENSE
DEPARTMENT OF DEFENSE
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
MIL-STD-883
MIL-STD-1835 -
MIL-HDBK-103 -
MIL-HDBK-780 -
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43216-5000
-
STANDARD
Test Method Standard Microcircuits.
Interface Standard Electronic Component Case Outlines.
List of Standard Microcircuit Drawings.
Standard Microcircuit Drawings.
SIZE
A
REVISION LEVEL
D
SHEET
5962-86716
4