DEMO908QC16 Freescale, DEMO908QC16 Datasheet - Page 2

• Manufacturer Part Number: DEMO908QC16
• Manufacturer: Freescale

Specifications of DEMO908QC16

• Architecture: 8/16-bit
• Code Gen Tools Included: Code Warrior
• Lead Free Status / RoHS Status: Not Compliant

Introduction and Default Settings
Use the USB-MON08 to Install DEMO908C16_ATD Program
The USB-MON08 allows a user to program the MCU FLASH and debug application via USB connection.
2
10.
11.
12.
13.
4.
5.
6.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Press the RESET switch and LED1 will flash with a frequency of approximately 500 MHz.
Press SW1: LED1 will flash with a frequency of approximately 2 Hz.
Press SW2: LED2 will flash with a frequency of approximately 8 Hz.
On the Axiom CD (“Examples” folder), copy the “DEMO908QC16_ATD.zip” file to your PC, open, and extract
the files into a working folder on your desktop. Note: Be sure to extract, and not just copy, the files.
Open CodeWarrior HC(S)08 v5.0 and open the “DEMO908QC16_ATD.mcp” project file.
Open “DEMO908C16_ATD.c” in the source folder by double clicking on “DEMO908QC16_ATD.c”.
Unplug the USB cable.
Check the jumper settings and make sure they are in the debug position in figure 2.
Connect the USB cable. The USB LED, PWR OUT, and +5V LED should be on.
Click on “Debug” under Project in the menu bar or hit “F5.” The True-Time Simulator & Real-Time Debugger
interface window will appear. Please follow the instructions on the screen to complete the Flash
programming process.
If the “Attempting to contact target and pass security…” window appears, please make sure the following
options are configured correctly:
–
–
–
–
–
Click the “Contact target with these settings…” button and follow the instructions on the screen. When the
“Erase and Program Flash?” window appears, click the “Yes” button.
The “CPROG08SZ Programmer” window should close after the MCU FLASH is programmed. You are now
ready to run the DEMO908QC16_ATD code.
Install jumper RZ1 on the USER_EN header.
Click on the green arrow in the toolbar at the top of the screen to run the program. After you click this button,
a message in the command window (bottom right-hand side) should say “RUNNING”.
LED1 and LED2 will change according to amount of light the photo cell (RZ1) is receiving.
USB-ML-MON08 REF: DEMO908QC16 on USB1 (Depends on the PC USB Port)
Device Power: 5 Volts, provided by P&E Interface
Device Clock: Clock Driven by P&E Interface on Pin 13
Frequency: 5.000 Mhz
Target MCU Security bytes: Check the “IGNORE security failure and enter monitor mode” checkbox
USB-MON08 ENABLE
D
C
B
E
F
J
I
Figure 2. DEMO908QC16 Debug Settings
DEMO908QC16 Quick Start Guide, Rev. 0.02
USER_EN
SW1
SW2
LED1
LED2
LED3
LED4
RV1
RZ1
Freescale Semiconductor