LU82541PI Intel, LU82541PI Datasheet - Page 13

• Manufacturer Part Number: LU82541PI
• Manufacturer: Intel

Specifications of LU82541PI

• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 196
• Lead Free Status / RoHS Status: Compliant

3.2.2
3.2.3
3.2.4
Arbitration Signals (2)
Interrupt Signal (1)
System Signals (4)
IDSEL
DEVSEL#
VIO
REQ#
GNT#
INTA#
CLK
M66EN
RST#
CLK_RUN#
Symbol
Symbol
Symbol
Symbol
I
STS
P
TS
I
TS
I
I
I
I/O
OD
Type
Type
Type
Type
Initialization Device Select. The Initialization Device Select signal is used by the
82541(PI/GI/EI) as a chip select signal during configuration read and write transactions.
Device Select. When the Device Select signal is actively driven by the 82541(PI/GI/
EI), it signals the bus master that it has decoded its address as the target of the current
access. As an input, DEVSEL# indicates whether any device on the bus has been
selected.
VIO. The VIO signal is a voltage reference for the PCI interface (3.3 V or 5 V PCI
signaling environment). It is used as the clamping voltage.
Note: VIO should be connected to 3.3 V Aux or 5 V Aux in order to be compatible with
the pull-up clamps specification.
Request Bus. The Request Bus signal is used to request control of the bus from the
arbiter. This signal is point-to-point.
Grant Bus. The Grant Bus signal notifies the 82541(PI/GI/EI) that bus access has
been granted. This is a point-to-point signal.
Interrupt A. Interrupt A is used to request an interrupt of the 82541(PI/GI/EI). It is an
active low, level-triggered interrupt signal.
PCI Clock. The PCI Clock signal provides timing for all transactions on the PCI bus
and is an input to the 82541(PI/GI/EI) device. All other PCI signals, except the Interrupt
A (INTA#) and PCI Reset signal (RST#), are sampled on the rising edge of CLK. All
other timing parameters are defined with respect to this edge.
66 MHz Enable. M66EN indicates whether the system bus is enabled for 66MHz.
PCI Reset. When the PCI Reset signal is asserted, all PCI output signals, except the
Power Management Event signal (PME#), are floated and all input signals are ignored.
The PME# context is preserved, depending on power management settings.
Most of the internal state of the 82541(PI/GI/EI) is reset on the de-assertion (rising
edge) of RST#.
Clock Run. This signal is used by the system to pause the PCI clock signal. It is used
by the 82541(PI/GI/EI) controller to request the PCI clock. When the CLK_RUN#
feature is disabled, leave this pin unconnected.
Name and Function
Name and Function
Name and Function
Name and Function
Networking Silicon — 82541(PI/GI/EI)
13