PEB4265TV1.2T Infineon Technologies, PEB4265TV1.2T Datasheet - Page 184

• Manufacturer Part Number: PEB4265TV1.2T
• Manufacturer: Infineon Technologies

Specifications of PEB4265TV1.2T

• On-hook Transmission: Yes
• Polarity Reversal: Yes
• On-chip Ring Relay Driver: Yes
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Pin Count: 22
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Supplier Unconfirmed

Preliminary
Bit
The mask bits in the mask register only influence the generation of an interrupt. Even if
the mask bit is set to 1, the corresponding status bit in the INTREGx registers gets
updated to show the current status of the corresponding event.
READY-M Mask bit for Ramp Generator READY bit
HOOK-M
GNDK-M
GNKP-M
ICON-M
VRTLIM-M Mask bit for Programmed Voltage Limit VRTLIM bit
Data Sheet
11
H
MASK
READY
-M
7
READY-M = 0
READY-M = 1
Mask bit for Off-hook Detection HOOK bit
HOOK-M = 0
HOOK-M = 1
Mask bit for Ground Key Detection GNDK bit
GNDK-M = 0
GNDK-M = 1
Mask bit for Ground Key Level GNKP bit
Mask bit for Constant Current Information ICON bit
ICON-M = 0
ICON_M = 1
VRTLIM-M = 0
VRTLIM-M = 1
GNKP-M = 0
GNKP-M = 1
HOOK
-M
6
Mask Register
GNDK
-M
Each change of the GNKP bit generates an interrupt.
Changes of the GNKP bit don’t generate interrupts.
Each change of the ICON bit generates an interrupt.
Changes of the ICON bit don’t generate interrupts.
An interrupt is generated if the READY bit changes from
0 to 1.
Changes of the READY bit don’t generate interrupts.
Each change of the HOOK bit generates an interrupt.
Changes of the HOOK bit don’t generate interrupts.
Each change of the VRTLIM bit generates an interrupt.
Changes of the VRTLIM bit don’t generate interrupts.
Each change of the GNDK bit generates an interrupt.
Changes of the GNDK bit don’t generate interrupts.
5
SLICOFI-2x Command Structure and Programming
GNKP
-M
4
184
ICON
-M
3
VRTLIM
-M
2
FF
DuSLIC-E/-E2/-P
OTEMP
H
-M
1
2000-07-14
SYNC
-M
0
Y