MCP23S09T-E/MG Microchip Technology, MCP23S09T-E/MG Datasheet - Page 28

• Manufacturer Part Number: MCP23S09T-E/MG
• Description: 8-bit Input/Output Expander, SPI Interface 16 QFN 3x3x0.9mm T/R
• Manufacturer: Microchip Technology

Specifications of MCP23S09T-E/MG

• Interface: SPI
• Number Of I /o: 8
• Interrupt Output: Yes
• Frequency - Clock: 10MHz
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 16-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

MCP23009/MCP23S09
1.7.5
There are two possible configurations to cause
interrupts (configured via INTCON):
1.
2.
See
on interrupt operations.
DS22121B-page 28
Pins configured for interrupt-on-pin-change
will cause an interrupt to occur if a pin changes
to the opposite state. The default state is reset
after an interrupt occurs. For example, an
interrupt occurs by an input changing from 1 to
0. The new initial state for the pin is a logic 0.
Pins configured for interrupt-on-change from
register value will cause an interrupt to occur if
the corresponding input pin differs from the
register bit. The interrupt condition will remain as
long as the condition exists, regardless if the
INTAP or GPIO is read.
Figure 1-11
INTERRUPT CONDITIONS
and
Figure 1-12
for more information
FIGURE 1-11:
FIGURE 1-12:
GP:
GP2
INT
GPx
Port value
is captured
into INTCAP
INT
Port value
is captured
into INTCAP
7
X
6
X
ACTIVE
ACTIVE
5
X
INTERRUPT-ON-PIN-
CHANGE
Read GPIO
or INTCAP
INTERRUPT-ON-CHANGE
FROM REGISTER
DEFAULT
© 2009 Microchip Technology Inc.
DEFVAL
4
X
(INT clears only if interrupt
condition does not exist.)
3
X
Read GPIO
or INTCAP
ACTIVE
2
1
Port value
is captured
into INTCAP
ACTIVE
1
X
0
X