PIC18F45K20-E/P Microchip Technology, PIC18F45K20-E/P Datasheet - Page 42

• Manufacturer Part Number: PIC18F45K20-E/P
• Description: 32KB, Flash, 1536bytes-RAM, 36I/O, 8-bit Family,nanowatt XLP 40 PDIP .600in TUBE
• Manufacturer: Microchip Technology
• Series: PIC® XLP™ 18Fr

Specifications of PIC18F45K20-E/P

• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 48MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, HLVD, POR, PWM, WDT
• Number Of I /o: 35
• Program Memory Size: 32KB (16K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 1.5K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Data Converters: A/D 14x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 40-DIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: DM240313 - BOARD DEMO 8BIT XLPAC164112 - VOLTAGE LIMITER MPLAB ICD2 VPPDM164124 - KIT STARTER FOR PIC18F4XK20
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PICkit™ 3 Debug Express
FIGURE 3-27:
DS41370C-page 38
3.6.2
The PICkit 3 cannot be used as a programmer and debugger at the same time, so if
PICkit 3 is currently selected as a programmer, selecting it as a debugger will cause it
to be disabled as a programmer.
To enable the PICkit 3 as a debugger in the MPLAB IDE select Debugger > Select Tool
> 2 PICkit 3. The Output window will display the connection to the target microcontroller
as in Figure 3-10A.
To Begin Debugging
• In the MPLAD IDE toolbar, change the project configuration from “Rlease” to
• Build the project: Project > Build All
• Program the target microcontroller: Debugger > Program
• Select Debugger > Run to begin program execution.
The Lesson 5 code is now running in Debug mode. The LEDs will rotate and the button
may be pressed to reverse them, as the target microcontroller will operate in Debug
mode just as it normally would.
3.6.3
3.6.3.1
The PIC18F45K20 on the demo board is now running the lesson program code. Code
execution can be halted (stopped) at any time by selecting Debugger > Halt <F5>. A
green arrow on the left margin of the MPLAB IDE editor window will show the next
statement to be executed. Your code will probably have stopped in a different place
than that shown in Figure 3-27.
GREEN ARROW POINTS TO NEXT STATEMENT TO EXECUTE
“Debug”.
Note:
Selecting PICkit 3 as a Debugger in the MPLAB IDE
Basic Debug Operations
HALT
An ICD ‘i’ Linker Script must be used when debugging, as discussed in
Section 3.1.1 of this document. The lesson projects already use the correct
Linker Script, 18f45k20 i.lkr.
© 2009 Microchip Technology Inc.