MMDOE28G5MPP-0VA Samsung Semiconductor, MMDOE28G5MPP-0VA Datasheet - Page 33

• Manufacturer Part Number: MMDOE28G5MPP-0VA
• Manufacturer: Samsung Semiconductor

Specifications of MMDOE28G5MPP-0VA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

7.3.8 Error reporting
The following table shows the values returned in the Status and Error Registers when specific error conditions are encountered by a device.
8.0 OOB signaling and Phy Power State
8.1 OOB signaling
8.1.1 OOB signal spacing
There shall be three Out Of Band (OOB) signals used/detected by the Phy: COMRESET,COMINIT, and COMWAKE. Each burst is followed
by idle periods (at common-mode levels), having durations as depicted in following Figure and Table. The COMWAKE OOB signaling is used
to bring the Phy out of a power-down state (Partial or Slumber)
MMCRE64G5MPP-0VA
A S.M.A.R.T. FUNCTION SET command was received by the device without the required key
being loaded into the LBA High and LBA Mid registers.
A S.M.A.R.T. FUNCTION SET command was received by the device with a subcommand value
in the Features Register that is either invalid or not supported by this
device.
A S.M.A.R.T. FUNCTION SET command subcommand other than S.M.A.R.T. ENABLE OPERA-
TIONS was received by the device while the device was in a "S.M.A.R.T. Disabled" state.
The device is unable to read its Attribute Values or Attribute Thresholds data structure
The device is unable to write to its Attribute Values data structure.
Time
T1
T2
Error condition
Table 7-9: SMART Error Codes
33
106.7 ns
320 ns
Value
51h
51h
51h
51h
51h
Status Register
04h
04h
04h
10h or 04h
10h or 40h
Error Register
Final