5962-8948403MXA QP SEMICONDUCTOR, 5962-8948403MXA Datasheet - Page 17

• Manufacturer Part Number: 5962-8948403MXA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-8948403MXA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
MIL-PRF-38535, MIL-STD-1331, and as follows:
requirements are specified from the external system point of view. For example, address setup time would be shown as a
minimum since the system must supply at least that much time (even though most devices do not require it). On the other hand,
responses from the memory are specified from the device point of view. For example, the access time would be shown as a
maximum since the device never provides data later than that time.
The vendors listed in QML-38535 have submitted a certificate of compliance (see 3.6 herein) to DSCC-VA and have agreed to
this drawing.
The vendors listed in MIL-HDBK-103 have agreed to this drawing and a certificate of compliance (see 3.6 herein) has been
submitted to and accepted by DSCC-VA.
6.5 Symbols, definitions, and definitions. The abbreviations, symbols, and definitions used herein are defined in
6.5.1 Timing limits. The table of timing values shows either a minimum or a maximum limit for each parameter. Input
6.5.2 Waveforms.
6.6 Sources of supply.
6.6.1 Sources of supply for device classes Q and V. Sources of supply for device classes Q and V are listed in QML-38535.
6.6.2 Approved sources of supply for device class M. Approved sources of supply for class M are listed in MIL-HDBK-103.
C IN ......................................... Input terminal capacitance.
C OUT ..................................... Output terminal capacitance.
GND....................................... Ground zero voltage potential.
I CC ......................................... Supply current.
I IX .......................................... Input current.
I OZ ......................................... Output current.
T C .......................................... Case temperature.
V CC ....................................... Positive supply voltage.
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
STANDARD
Waveform
symbol
MUST BE
VALID
CHANGE FROM
H TO L
CHANGE FROM
L TO H
DON'T CARE
ANY CHANGE
PERMITTED
Input
SIZE
A
WILL BE
VALID
WILL CHANGE
FROM
H TO L
WILL CHANGE
FROM
L TO H
CHANGING
STATE
UNKNOWN
HIGH
IMPEDANCE
REVISION LEVEL
Output
A
SHEET
5962-89484
17