PPC405EP-3GB266C Applied Micro Circuits Corporation, PPC405EP-3GB266C Datasheet - Page 29

• Manufacturer Part Number: PPC405EP-3GB266C
• Manufacturer: Applied Micro Circuits Corporation

Specifications of PPC405EP-3GB266C

• Family Name: 405EP
• Device Core: PowerPC
• Device Core Size: 32b
• Frequency (max): 266MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 1.8V
• Operating Supply Voltage (max): 1.95V
• Operating Supply Voltage (min): 1.65V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 385
• Package Type: EBGA
• Lead Free Status / RoHS Status: Not Compliant

PPC405EP – PowerPC 405EP Embedded Processor
Signal List
The following table provides a summary of the number of package pins associated with each functional interface
group.
Table 5. Pin Summary
In the table “Signal Functional Description” on page 31, each external signal is listed along with a short description
of the signal function. Active-low signals (for example, RAS) are marked with an overline. Please see “Signals
Listed Alphabetically” on page 13 for the pin (ball) number to which each signal is assigned.
Multiplexed Pins
Some signals are multiplexed on the same package pin (ball) so that the pin can be used for different functions. In
most cases, the signal names shown in this table are not accompanied by signal names that may be multiplexed
on the same pin. If you need to know what, if any, signals are multiplexed with a particular signal, look up the name
in “Signals Listed Alphabetically” on page 13. It is expected that in any single application a particular pin will always
be programmed to serve the same function. The flexibility of multiplexing allows a single chip to offer a richer pin
selection than would otherwise be possible.
In addition to multiplexing, many pins are also multi-purpose. For example, in the PCI interface PCIC3:0/BE3:0
serves as both Command and Byte Enable signals. In this example, the pins are also bidirectional, serving as both
inputs and outputs.
Initialization Strapping
One group of pins is used as strapped inputs during system reset. These pins function as strapped inputs only
during reset and are used for other functions during normal operation (see “Initialization” on page 49). Note that the
use of these pins for strapping is not considered multiplexing since the strapping function is not programmable.
Pull-Up and Pull-Down Resistors
Pull-up and pull-down resistors are used for strapping during reset and to retain unused or undriven inputs in an
appropriate state. The recommended pull-up value of 3kΩ to +3.3V (10kΩ to +5V can be used on 5V tolerant I/Os)
and pull-down value of 1kΩ to GND, applies only to individually terminated signals. To prevent possible damage to
the device, I/Os capable of becoming outputs must never be tied together and terminated through a common
resistor.
If your system-level test methodology permits, input-only signals can be connected together and terminated
through either a common resistor or directly to +3.3V or GND. When a resistor is used, its value must ensure that
the grouped I/Os reach a valid logic zero or logic one state when accounting for the total input current into the
PPC405EP.
AMCC
Thermal (and Gnd)
Total Signal Pins
Non multiplexed
Multiplexed
Total Pins
Reserved
Group
OV
Gnd
V
DD
DD
No. of Pins
Revision 1.08 – March 24, 2008
215
248
385
33
43
16
53
25
0
Data Sheet
29