5962-8984105KA QP SEMICONDUCTOR, 5962-8984105KA Datasheet - Page 4

• Manufacturer Part Number: 5962-8984105KA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-8984105KA

• Lead Free Status / RoHS Status: Not Compliant

DEFENSE SUPPLY CENTER COLUMBUS
DSCC FORM 2234
APR 97
drawing.
characteristics are as specified in table I and shall apply over the full case operating temperature range.
electrical tests for each subgroup are described in table I.
PIN listed in 1.2 herein. In addition, the manufacturer's PIN may also be marked as listed in MIL-HDBK-103 (see 6.6
herein). For packages where marking of the entire SMD PIN number is not feasible due to space limitations, the
manufacturer has the option of not marking the "5962-" on the device.
compliance to MIL-PRF-38535, appendix A. The compliance indicator “C” shall be replaced with a "Q" or "QML"
certification mark in accordance with MIL-PRF-38535 to identify when the QML flow option is used.
as an approved source of supply in MIL-HDBK-103 (see 6.6 herein). The certificate of compliance submitted to
DSCC-VA prior to listing as an approved source of supply shall affirm that the manufacturer's product meets the
requirements of MIL-PRF-38535, appendix A and the requirements herein.
provided with each lot of microcircuits delivered to this drawing.
appendix A.
manufacturer's facility and applicable required documentation. Offshore documentation shall be made available
onshore at the option of the reviewer.
COLUMBUS, OHIO 43216-5000
3.2.2 Truth table. The truth table shall be as specified on figure 2.
3.2.2.1 Unprogrammed devices. The truth table for unprogrammed devices shall be as specified on figure 2.
3.2.2.2 Programmed devices. The truth table for programmed devices shall be as specified by an attached altered item
3.2.3 Case outlines The case outlines shall be in accordance with 1.2.2 herein.
3.3 Electrical performance characteristics. Unless otherwise specified herein, the electrical performance
3.4 Electrical test requirements. The electrical test requirements shall be the subgroups specified in table II. The
3.5 Marking. Marking shall be in accordance with MIL-PRF-38535, appendix A. The part shall be marked with the
3.5.1 Certification/compliance mark. A compliance indicator “C” shall be marked on all non-JAN devices built in
3.6 Certificate of compliance. A certificate of compliance shall be required from a manufacturer in order to be listed
3.7 Certificate of conformance. A certificate of conformance as required in MIL-PRF-38535, appendix A shall be
3.8 Notification of change. Notification of change to DSCC-VA shall be required in accordance with MIL-PRF-38535,
3.9 Verification and review. DSCC, DSCC's agent, and the acquiring activity retain the option to review the
MICROCIRCUIT DRAWING
STANDARD
SIZE
A
REVISION LEVEL
J
SHEET
5962-89841
4