54FCT521LMQB. National Semiconductor, 54FCT521LMQB. Datasheet - Page 10

• Manufacturer Part Number: 54FCT521LMQB.
• Manufacturer: National Semiconductor

Specifications of 54FCT521LMQB.

• Lead Free Status / RoHS Status: Not Compliant

DSCC FORM 2234
APR 97
appendix A.
prior to quality conformance inspection. The following additional criteria shall apply:
MIL-STD-883 including groups A, B, C, and D inspections. The following additional criteria shall apply.
4. VERIFICATION
4.1 Sampling and inspection. Sampling and inspection procedures shall be in accordance with MIL-PRF-38535,
4.2 Screening. Screening shall be in accordance with method 5004 of MIL-STD-883, and shall be conducted on all devices
4.3 Quality conformance inspection. Quality conformance inspection shall be in accordance with method 5005 of
4.3.1 Group A inspection.
a. Burn-in test, method 1015 of MIL-STD-883.
b. Interim and final electrical test parameters shall be as specified in table II herein, except interim electrical parameter
a.
b.
c.
d.
(1) Test condition A, B, C, or D. The test circuit shall be maintained by the manufacturer under document revision level
(2) T
tests prior to burn-in are optional at the discretion of the manufacturer.
DEFENSE SUPPLY CENTER COLUMBUS
Tests shall be as specified in table II herein.
Subgroups 5 and 6 in table I, method 5005 of MIL-STD-883 shall be omitted.
Subgroup 4 (C
changes which may affect input capacitance. Test all applicable pins on 5 devices with zero failures.
Subgroup 7 and 8 tests shall include verification of the truth table as specified on figure 2.
control and shall be made available to the preparing or acquiring activity upon request. The test circuit shall specify
the inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in method
1015 of MIL-STD-883.
A
MICROCIRCUIT DRAWING
= +125C, minimum.
COLUMBUS, OHIO 43218-3990
STANDARD
IN
and C
Interim electrical parameters
Final electrical test parameters
Group A test requirements
Groups C and D end-point
MIL-STD-883 test requirements
(method 5004)
(method 5004)
(method 5005)
electrical parameters
(method 5005)
* PDA applies to subgroup 1.
OUT
measurements) shall be measured only for the initial test and after process or design
TABLE II. Electrical test requirements.
MIL-STD-883, method 5005, table I)
1, 2, 3, 4, 7, 8, 9, 10, 11
SIZE
1*, 2, 3, 7, 8, 9, 10, 11
A
(in accordance with
Subgroups
1, 2, 3
- - -
REVISION LEVEL
D
SHEET
5962-88543
10