ICS952302AGT IDT, Integrated Device Technology Inc, ICS952302AGT Datasheet - Page 11

• Manufacturer Part Number: ICS952302AGT
• Description: IC FREQ GENERATOR 48-TSSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Frequency Generatorr

Specifications of ICS952302AGT

• Input: Crystal
• Output: Clock
• Frequency - Max: 48MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 48-TSSOP
• Frequency-max: 48MHz
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 952302AGT

The I/O pins designated by (input/output) serve as dual
signal functions to the device. During initial power-up,
they act as input pins. The logic level (voltage) that is
present on these pins at this time is read and stored into
a 5-bit internal data latch. At the end of Power-On reset,
(see AC characteristics for timing values), the device
changes the mode of operations for these pins to an
output function. In this mode the pins produce the
specified buffered clocks to external loads.
To program (load) the internal configuration register for
these pins, a resistor is connected to either the VDD
(logic 1) power supply or the GND (logic 0) voltage
potential. A 10 Kilohm (10K) resistor is used to provide
both the solid CMOS programming voltage needed during
the power-up programming period and to provide an
insignificant load on the output clock during the subsequent
operating period.
Shared Pin Operation -
Input/Output Pins
0957B—10/05/04
Device
Pad
Programming
Header
Via to Gnd
Series Term. Res.
Fig. 1
11
Figure 1 shows a means of implementing this function
when a switch or 2 pin header is used. With no jumper is
installed the pin will be pulled high. With the jumper in
place the pin will be pulled low. If programmability is not
necessary, than only a single resistor is necessary. The
programming resistors should be located close to the
series termination resistor to minimize the current loop
area. It is more important to locate the series termination
resistor close to the driver than the programming resistor.
8.2K
2K
Clock trace to load
Via to
VDD
ICS952302