PCK946BD,151 NXP Semiconductors, PCK946BD,151 Datasheet - Page 11

• Manufacturer Part Number: PCK946BD,151
• Description: IC DRVR CLK CMOS 1:10 32LQFP
• Manufacturer: NXP Semiconductors
• Type: Fanout Buffer (Distribution), Divider, Multiplexerr

Specifications of PCK946BD,151

• Number Of Circuits: 1
• Ratio - Input:output: 2:10
• Differential - Input:output: No/No
• Input: LVCMOS, LVTTL
• Output: CMOS
• Frequency - Max: 150MHz
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 32-LQFP
• Frequency-max: 150MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 935281249151; PCK946BD-S; PCK946BD-S

Philips Semiconductors
13. Abbreviations
14. Revision history
Table 11:
9397 750 12296
Product data sheet
Document ID
PCK946_1
Revision history
Release date
20051213
[4]
[5]
[6]
[7]
[8]
[9]
Table 10:
Acronym
CMOS
LVCMOS
LVTTL
These packages are not suitable for wave soldering. On versions with the heatsink on the bottom side, the
solder cannot penetrate between the printed-circuit board and the heatsink. On versions with the heatsink
on the top side, the solder might be deposited on the heatsink surface.
If wave soldering is considered, then the package must be placed at a 45 angle to the solder wave
direction. The package footprint must incorporate solder thieves downstream and at the side corners.
Wave soldering is suitable for LQFP, QFP and TQFP packages with a pitch (e) larger than 0.8 mm; it is
definitely not suitable for packages with a pitch (e) equal to or smaller than 0.65 mm.
Wave soldering is suitable for SSOP, TSSOP, VSO and VSSOP packages with a pitch (e) equal to or larger
than 0.65 mm; it is definitely not suitable for packages with a pitch (e) equal to or smaller than 0.5 mm.
Image sensor packages in principle should not be soldered. They are mounted in sockets or delivered
pre-mounted on flex foil. However, the image sensor package can be mounted by the client on a flex foil by
using a hot bar soldering process. The appropriate soldering profile can be provided on request.
Hot bar soldering or manual soldering is suitable for PMFP packages.
Abbreviations
Data sheet status
Product data sheet
Description
Complementary Metal Oxide Silicon
Low Voltage Complementary Metal Oxide Silicon
Low Voltage Transistor-Transistor Logic
Rev. 01 — 13 December 2005
Change notice
-
Low voltage 1 : 10 CMOS clock driver
Doc. number
9397 750 12296
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Supersedes
-
PCK946
11 of 13