1-1761612-2 TE Connectivity, 1-1761612-2 Datasheet - Page 4

• Manufacturer Part Number: 1-1761612-2
• Description: STEP-Z 12MM PLUG 104P
• Manufacturer: TE Connectivity

Specifications of 1-1761612-2

• Solder Ball: Tin-Lead
• Product Height: 12mm
• Number Of Positions: 104
• Vacuum Cover: With
• Contact Type: Tab
• Contact Base Material: Copper Alloy
• Contact Finish: Gold (30) over Nickel (50)
• Connector Style: Plug
• Housing Material: Thermoplastic - GF
• Stack Height (mm [in]): 17.00 [0.669], 23.00 [0.905], 27.00 [1.063]
• Rohs/elv Compliance: ELV compliant, 5 of 6 Compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C
• Packaging Method: Tray

Disturbed interface.
Temperature cycling.
Humidity-temperature cycling.
High temperature life.
Thermal shock.
Rev B
Test Description
See Note.
Any measured resistance
exceeding 100% increase in total
resistance from initial value
recorded at hot temperature, shall
be considered an open. An open
followed by 10 additional opens
shall be considered a failure. The
time to failure shall be recorded as
the first open cycle of the failure
sequence.
See Note.
See Note.
See Note.
No discontinuities of 1 microsecond
or longer duration.
See Note.
Figure 1 (continued)
ENVIRONMENTAL
Requirement
Interface shall be disturbed so that
contact surfaces move about 0.10
mm or less.
Subject specimens to temperature
range between 0 and 100 ± 5
Temperature ramp shall be < 20
per minute (<10
preferred). Dwell at each
temperature extreme for a minimum
of 15 minutes after printed circuit
board reaches temperature. Cycle
time shall be approximately 60
minutes (24 test cycles per day).
Specimens shall be tested until
63.2% of the specimens (18
connectors) have failed or until
2670 cycles have been completed.
EIA-364-31, Method III.
Subject mated specimens to 50
cycles (500 hours) between 25 and
65
ramp shall be 1 hour per transition
with 3 hour minimum dwell at 65
EIA-364-17, Method A, Test
Condition 3, Test Time Condition C.
Subject mated specimens to 85
for 500 hours.
EIA-364-32, Test Condition I.
Subject mated specimens to 5
cycles between -55 and 85
Temperature transfer rate shall be <
1 minute with 30 minute dwell at
each temperature extreme.
/
C at 95% RH. Temperature
Procedure
/
C per minute
108-2143
/
C .
/
C .
4 of 8
/
/
/
C
C .
C