DS1075M-80 Maxim Integrated Products, DS1075M-80 Datasheet - Page 10
![ECONOSCILLATOR/DIV 80MHZ 8-DIP](/photos/1/39/13900/175-8-dip_sml.jpg)
DS1075M-80
Manufacturer Part Number
DS1075M-80
Description
ECONOSCILLATOR/DIV 80MHZ 8-DIP
Manufacturer
Maxim Integrated Products
Series
EconOscillator™r
Type
Oscillator, Fixed Frequency, Dualr
Datasheet
1.DS1075Z-803.pdf
(18 pages)
Specifications of DS1075M-80
Frequency
80MHz
Voltage - Supply
4.75 V ~ 5.25 V
Current - Supply
35mA
Operating Temperature
0°C ~ 70°C
Package / Case
8-DIP (0.300", 7.62mm)
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Count
-
DS1075
Figure 9
POWER-ON RESET
When power is initially applied to the device supply pin, a power-on reset sequence is executed, similar
to that which occurs when the device is restored from a power-down condition. This sequence comprises
two stages, first a conventional POR to initialize all on-chip circuitry, followed by a stabilization period
to allow the oscillator to reach a stable frequency before enabling the outputs:
1. Initialize internal circuitry.
2. Enable internal oscillator and/or OSCIN buffer.
3. Set M and N to maximum values.
4. Wait approximately 256 cycles of MCLK for the oscillator to stabilize.
5. Load M and N programmed values from EEPROM.
6. Enable OUT0 (assuming EN0=0).
7. Enable OUT.
Figure 10
PROGRAMMING
Normally when power is applied to the supply voltage pin the device will enter its normal operating mode
following the power-on reset sequence. However the device can be made to enter a programming mode if
a pull-up resistor is connected between IN/OUT and the supply voltage pin, prior to power-up. The
method used for programming is a variant of the 1-Wire
protocol used on a number of Dallas
™
Semiconductor products.
10 of 18