LTC1407CMSE#PBF Linear Technology, LTC1407CMSE#PBF Datasheet - Page 19

• Manufacturer Part Number: LTC1407CMSE#PBF
• Description: IC ADC 12BIT 3MSPS 10-MSOP
• Manufacturer: Linear Technology

Specifications of LTC1407CMSE#PBF

• Number Of Bits: 12
• Sampling Rate (per Second): 3M
• Data Interface: Serial, SPI™
• Number Of Converters: 1
• Power Dissipation (max): 14mW
• Voltage Supply Source: Single Supply
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 10-TFSOP, 10-MSOP (0.118", 3.00mm Width) Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

APPLICATIONS INFORMATION
;
bufull:
;
bsend
;
;======================================================================
;
;
;
;======================================================================
; ***************************************************************************
; File: BVECTORS.ASM -> Vector Table for the ‘C54x DSKplus
;
;
; ***************************************************************************
; The vectors in this table can be confi gured for processing external and
; internal software interrupts. The DSKplus debugger uses four interrupt
; vectors. These are RESET, TRAP2, INT2, and HPIINT.
;
;
; All other vector locations are free to use. When programming always be sure
; the HPIINT bit is unmasked (IMR=200h) to allow the communications kernel and
; host PC interact. INT2 should normally be masked (IMR(bit 2) = 0) so that the
; DSP will not interrupt itself during a HINT. HINT is tied to INT2 externally.
;
;
;
VECTORS
*
——————————— end ISR ——————————————
DO NOT MODIFY THESE FOUR VECTORS IF YOU PLAN TO USE THE DEBUGGER
———————mask and shift input data ——————————————
b = *ar3+ << -0
b = #07FFFh & b
*ar2+ = data(#0bh)
TC = (@ar2 == #02000h)
if (TC) goto start
goto bufull
—————————dummy bsend return————————————
return_enable
.copy “c:\dskplus\1407A\s2k14ini.asm”
.space 16*32
.sect “vectors”
.copy “c:\dskplus\1407A\bvectors.asm”
.sect “buffer”
.space 16*0x800
.sect “result”
.space 16*0x800
.end
BSP vectors and Debugger vectors
TDM vectors just return
; load acc b with BSP buffer and shift right -0
; mask out the TRISTATE bits with #03FFFh
;
; store B to out buffer and advance AR2 pointer
; output buffer is 2k starting at 1800h
; restart if out buffer is at 1fffh
;this is also a dummy return to defi ne bsend
;in vector table fi le BVECTORS.ASM
;clear a chunk at the end to mark the end
;Set address of BSP buffer for clearing
;Set address of result for clearing
;The vectors start here
;initialize buffered serial port
;get BSP vectors
LTC1407/LTC1407A
10.Jul.96
*
19
1407fb