MAX1003CAX+ Maxim Integrated Products, MAX1003CAX+ Datasheet - Page 10

• Manufacturer Part Number: MAX1003CAX+
• Description: IC ADC 6BIT 90MSPS DL 36-SSOP
• Manufacturer: Maxim Integrated Products

Specifications of MAX1003CAX+

• Number Of Bits: 6
• Sampling Rate (per Second): 90M
• Data Interface: Parallel
• Number Of Converters: 2
• Power Dissipation (max): 941mW
• Voltage Supply Source: Single Supply
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 36-BSOP (0.300", 7.5mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Low-Power, 90Msps, Dual 6-Bit ADC
The MAX1003 is designed with separate analog and
digital power-supply and ground connections to isolate
high-current digital noise spikes from the more sensi-
tive analog circuitry. The high-current digital output
ground (OGND) and analog ground (GND) should be
at the same DC level, connected at only one location
on the board. This will provide best noise immunity and
improved conversion accuracy. Use of separate
ground planes is strongly recommended.
The entire board needs good DC bypassing for both
analog and digital supplies. Place the power-supply
bypass capacitors close to where the power is routed
onto the board, i.e., close to the connector. 10µF elec-
trolytic capacitors with low-ESR ratings are recom-
mended. For best effective bits performance, minimize
capacitive loading at the digital outputs. Keep the digi-
tal output traces as short as possible.
The MAX1003 requires a +5V ±5% power supply for
the analog supply (V
supply connected to V
Bypass each of the V
GND with high-quality ceramic capacitors located as
close to the package as possible (Table 2). Consult the
evaluation kit manual for a suggested layout and
bypassing scheme.
Table 2. Bypassing
10
__________Applications Information
Digital Q-Output
Oscillator/Clock
Digital I-Output
Analog Inputs
FUNCTION
______________________________________________________________________________________
Converter
SUPPLY
Buffer
CC
V
CC_
V
CCO
13
26
28
36
CC
6
8
) and a +3.3V ±300mV power
/
CCO
supply pins to its respective
BYPASS
for the logic outputs.
OGND
GND/
TO
11
12
27
27
19
7
CAPACITOR
VALUE
0.01µF
0.01µF
0.01µF
0.01µF
47pF
47pF
Signal-to-noise and distortion (SINAD) is the ratio of the
fundamental input frequency’s RMS amplitude to all
other ADC output signals. The output spectrum is limit-
ed to frequencies above DC and below one-half the
ADC sample rate.
The theoretical minimum analog-to-digital noise is
caused by quantization error, and results directly from
the ADC’s resolution: SNR = (6.02N + 1.76)dB, where
N is the number of bits of resolution. Therefore, a per-
fect 6-bit ADC can do no better than 38dB.
The FFT Plot (see Typical Operating Characteristics )
shows the result of sampling a pure 20MHz sinusoid at
a 90MHz clock rate. This FFT plot of the output shows
the output level in various spectral bands. The plot has
been averaged to reduce the quantization noise floor
and reveal the low-amplitude spurs. This emphasizes
the excellent spurious-free dynamic range of the
MAX1003.
The effective resolution (or effective number of bits) the
ADC provides can be measured by transposing the
equation that converts resolution to SINAD: N =
(SINAD - 1.76) / 6.02 (see Typical Operating
Characteristics ).
_____________Dynamic Performance