MAX500BCPE+ Maxim Integrated Products, MAX500BCPE+ Datasheet
MAX500BCPE+
Specifications of MAX500BCPE+
Related parts for MAX500BCPE+
MAX500BCPE+ Summary of contents
Page 1
... REG D REG D CONTROL LOGIC MAX500 SDA LOAD SCL ________________________________________________________________ Maxim Integrated Products For free samples & the latest literature: http://www.maxim-ic.com, or phone 1-800-998-8800 CMOS, Quad, Serial-Interface ____________________________Features Buffered Voltage Outputs Double-Buffered Digital Inputs Microprocessor and TTL/CMOS Compatible Requires No External Adjustments Two- or Three-Wire Cascadable Serial Interface ...
Page 2
CMOS, Quad, Serial-Interface 8-Bit DAC ABSOLUTE MAXIMUM RATINGS Power Requirements V to AGND...........................................................-0.3V, +17V DGND ..........................................................-0.3V, +17V DGND ..................................................-7V ...............................................................-0.3V, +24V DD SS Digital Input Voltage to DGND ....................-0.3V, ...
Page 3
ELECTRICAL CHARACTERISTICS—Dual Supplies (continued +11.4V to +16.5V -5V ±10%, AGND = DGND = 0V PARAMETER SYMBOL DYNAMIC PERFORMANCE Voltage Output Slew Rate V Settling Time OUT Digital Feedthrough Digital Crosstalk Output Load Resistance ...
Page 4
CMOS, Quad, Serial-Interface 8-Bit DAC ELECTRICAL CHARACTERISTICS—Single Supply (V = +15V ±5 AGND = DGND = 0V PARAMETER SYMBOL STATIC PERFORMANCE Resolution Total Unadjusted Error Relative Accuracy Differential Nonlinearity Full-Scale Error Full-Scale Tempco Zero-Code Error ...
Page 5
Operating Characteristics (continued) OUTPUT SINK CURRENT vs. OUTPUT VOLTAGE - 200 (V) OUT _______________Detailed Description ...
Page 6
CMOS, Quad, Serial-Interface 8-Bit DAC POSITIVE STEP (V = - s/div Figure 2. Positive and Negative Settling Times DYNAMIC RESPONSE (V = - s/div Figure 3. Dynamic Response sink, as well as ...
Page 7
A1 A0 SCL SDA LOAD LDAC SRO (SERIAL OUTPUT SCL t S1 SDA SRO t D1 Figure 5. 3-Wire Mode A1 SCL SDA LDAC SRO (SERIAL OUTPUT SCL t S1 SDA t D1 SRO t D1 ...
Page 8
CMOS, Quad, Serial-Interface 8-Bit DAC A low level on LOAD line initiates the transfer of data from the shift register to the addressed input register. The data can stay in this register until all four of the input registers are ...
Page 9
The SRO output swings from other MAX500s poses no problem. If SRO is used to drive a TTL-compatible input, use a clamp diode between TTL +5V and V and the current-limiting DD resistor to prevent potential latchup ...
Page 10
CMOS, Quad, Serial-Interface 8-Bit DAC Table 3. Unipolar Code Table DAC CONTENTS MSB LSB ...
Page 11
Using an AC Reference In applications where V has AC signal components, REF the MAX500 has multiplying capability within the limits of the V input range specifications. Figure 11 shows REF a technique for applying a sine-wave signal to the ...
Page 12
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. 12 __________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 (408) 737-7600 © 1996 Maxim Integrated Products ...