E2CY-V3A Omron, E2CY-V3A Datasheet - Page 15

• Manufacturer Part Number: E2CY-V3A
• Description: Proximity Sensors NON-FERROUS PROX HEA D FLAT
• Manufacturer: Omron
• Series: E2CYr

Specifications of E2CY-V3A

• Output Type: NPN
• Proximity Sensor Sensing Distance: 3mm
• Proximity Sensor Sensing Distance Range: 2 to 7mm
• Mounting: Panel
• Operating Temp Range: -10C to 55C
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 10V
• Operating Supply Voltage (typ): 12/15/18/24V
• Operating Supply Voltage (max): 30V
• Pin Count: 3
• Maximum Operating Temperature: + 55 C
• Operating Supply Voltage: 10 V to 30 V
• Sensing Distance: 3 mm
• Minimum Operating Temperature: - 10 C
• Sensor Type: Inductive
• Sensing Object: Metallic
• Response Frequency: -
• Material - Body: Zinc Die-Cast
• Shielding: Shielded
• Voltage - Supply: -
• Terminal Type: 3-Wire
• Package / Case: Box
• Lead Free Status / Rohs Status: Supplier Unconfirmed

J MUTUAL INTERFERENCE
If more than one Sensor is positioned face-to-face or in parallel,
be sure to maintain enough space, as provided in the following
table, between adjacent Sensors to suppress mutual
interference.
J AMPLIFIER UNIT MOUNTING AND
Mounting
1. Place the front part of the Amplifier Unit on the mounting
2. Press the rear part of the Amplifier Unit onto the mounting
If the Amplifier Unit is side-mounted to the bracket provided,
secure it using M3 screws with flat washers (6 mm in dia., or
less).
E2CY
Front part
Model
E2CY-X1R5A
E2CY-C2A
E2CY-V3A
bracket provided with the E2CY or the DIN track so that the
front part will engage with the mounting bracket or DIN track.
bracket or DIN track.
REMOVAL
Flat washers (6 dia. max. each)
(1)
Rear part
DIN track (or mounting bracket)
(2)
Distance (mm)
A
20
20
30
Fixture rail (yellow)
B
15
15
12
Removal
Press the Amplifier Unit in the direction shown by arrow (3) in the
following illustration and lift up the fiber insertion part of the
Amplifier Unit in the direction shown by arrow (4), so the Amplifier
Unit can be removed easily. No screwdriver is required to remove
the Amplifier Unit.
J TEACHING
Make sure that the Sensor is in operating condition before
making sensitivity adjustments.
J PROCESSING THE SENSOR CABLE
When cutting or extending the cable, the end of the sensor cable
connected to the E2CY-j must be processed as shown in the
following illustration.
Note:*1. Be sure to turn over the braided shield so that none of
J POWER ON OPERATION
•
•
J EFFECT OF HIGH-FREQUENCY
If the E2CY is located near a high-frequency generation unit or
transceiver, it may be affected by such a unit and result in
malfunction.
Sensor cable
The E2CY will be ready for sensing within 50 ms after the
power is turned ON.
When the E2CY and load are connected to different power
supplies, you must turn ON the power supply to the E2CY
first.
ENDS
ELECTRO-MAGNETIC FIELD
*2. Make sure that a minimum of 2.5 mm of cable
(4)
its thin wires are left.
insulation is maintained.
DIN track
(3)
14 max.
*1
*2
7 to 8
4 to 5
E2CY
15