LS029B4DN01 Sharp Electronics, LS029B4DN01 Datasheet - Page 4

• Manufacturer Part Number: LS029B4DN01
• Manufacturer: Sharp Electronics

Specifications of LS029B4DN01

• Lead Free Status / Rohs Status: Compliant

solvents as it may damage the LCD panel terminal area which uses organic material. Also, do not
directly touch with finger. When the terminals cleaning are needed, those should be wiped by a soft
cloth or a cotton swab without directly touching by hand.
(7) Do not expose gate driver, etc. on the panel (circuit area outside panel display area) to light as it
may not operate properly. Design that shields gate driver, etc. from light is required when mounting
the LCD module.
(8) To avoid circuit failure, do not touch panel terminal area.
(9) Support for the LCD panel should be carefully designed to avoid stress that exceeds specification
on glass surface.
(10) When handling LCD module and assembling them into cabinets, be noted that storage in the
environment of oxidization or deoxidization gas and the use of such materials as reagent, solvent,
adhesive, resin, and etc. which generate these gasses, may cause corrosion and discoloration of LCD
modules.
(11)To avoid picture uniformity failure, do not put a seal or an adhesive material on the panel surface.
(12) Do not use chloroprene rubber as it generates chlorine gas and affects reliability in LCD panel
connective area.
(13) Protective film is attached to the surface of UV protection film on LCD panel to prevent scratches
or other damages. Remove this protective film before use. In addition, do not attach the protective
film which is removed from LCD module again. When the LCD panel which has the reattached
protective film is stored for a long time, the UV protection film might have a damage with picture quality
failure.
(14) Panel is susceptible to mechanical stress and such stress may affect the display. Place the
panel on flat surface to avoid stress caused by twist, bend, etc.
(15) When transporting LCD panels, secure them in LCD panel tray to avoid mechanical stress. The
tray should be conductive to protect LCD panels from static charge.
Material used in set or epoxy resin (amine type hardening agent) from packaging, and silicon adhesive
(dealcoholized or oxime) all release gas which may affect quality of UV protection film. Do confirm
compatibility with user materials.
(16) As this LCD module is composed of electronic circuits, it is sensitive to electrostatic discharge of
200V or more. Handle with care and follow the instructions below:
Operators
Operators must wear anti-static wears to prevent electrostatic charge up to and discharge
from human body.
Equipment and containers
Process equipment such as conveyer, soldering iron, working bench and containers may
possibly generate electrostatic charge up and discharge. Equipment must be grounded
through 100Mohms resistance. Use ion blower.
Floor
Floor plays an important role in leaking static electricity generated in human body or
equipment. If the floor is made of insulated material (such as polymer or rubber material),
such static electricity may charge. Proper measure should be taken to avoid static electricity
charge (electrostatic earth:
charged to them without leakage in case of insulating floor, so the electrostatic earth:1×10
should be made.
Humidity
Humidity in work area relates to surface resistance of the persons or objects that generate
electrostatics, and it can be manipulated to prevent electrostatic charge. Humidity of 40% or
lower increases electrostatic earth resistance and promotes electrostatic charging. Therefore,
the humidity in the work area should be kept above 40%. Specifically for film peeling process
or processes that require human hands, humidity should be kept above 50% and use
electricity removal blower.
SPEC No.
LCY-12T09X02A
100Mohms).There is a possibility that the static electricity is
MODEL No.
LS029B4DN01
PAGE
2
8
Ω