LS029B4DN01 Sharp Electronics, LS029B4DN01 Datasheet - Page 6

• Manufacturer Part Number: LS029B4DN01
• Manufacturer: Sharp Electronics

Specifications of LS029B4DN01

• Lead Free Status / Rohs Status: Compliant

(1) Operation outside specified environmental conditions cannot be guaranteed.
(2) As power supply (VDD-GND) impedance is lowered during use, bus controller should be inserted
(3) UV protection film is applied over LCD panel surface. Liquid crystal inside LCD panel deteriorates
(4) Disassembling the LCD module will cause permanent damage to the module.
(5) If LCD panel is broken, do not ingest the liquid crystal from the broken panel. If hand, leg, or
(6) ODS (specific chlorofuorocarbon, specific halon, 1-1-1 trichloroethane, carbon tetrachloride) are
(7) Observe all other precautionary requirements in handling general electronic components.
LCD Panel : Dispose of as glass waste. This LCD module contains no harmful substances.
FPC
near LCD module as much as possible.
with ultraviolet ray. The panel should not be left in direct sun or under strong ultraviolet ray for
prolonged period of time even with the UV protection film.
disassemble the module.
clothes come in contact with liquid crystal, wash off immediately with soap.
not used or contained in material or all production processes of this product.
: (1) FPC bend R should be 0.6mm or greater and R should be even.
This liquid crystal panel contains only an extremely small amount of liquid crystal
(approximately 100mg) and therefore it will not leak even if the panel should break.
Its median lethal dose (LD50) is greater than 2,000 mg/kg and a mutagenetic (Aims
test: negative) material is used.
The liquid crystal panel contains no dangerous or harmful substances.
As for connective area of LCD panel, do not bend FPC into UV protection film side.
(2)Do not hang LCD module at FPC or apply force to FPC.
Discarding liquid crystal modules
SPEC No.
LCY-12T09X02A
[Other Notice]
MODEL No.
LS029B4DN01
PAGE
Do not
4