LQ10D368 Sharp Electronics, LQ10D368 Datasheet - Page 19

• Manufacturer Part Number: LQ10D368
• Manufacturer: Sharp Electronics

Specifications of LQ10D368

• Lead Free Status / Rohs Status: Compliant

Procedure to backlight replacement
Lamp which is used in the LCD module is consumable goods. When the lamp replacement is needed due to the
expiry of lamp-operating life, replace the lamp with lamp holder following with below procedure 1) to 4).
Make sure that the power supply of DC/AC inverter which operates the lamp is turned off before the lamp
replacement. Also, please wear fingerstall and be careful not to put any stain or scratch on the LCD panel.
Replacement procedure
(1) Put the module rear side on the top.
(2) Slide the edge (shaded area) of the lamp unit to the direction which arrow X indicates.
(3) Slide the lamp unit to the direction which arrow Y indicates, holding the edge of the lamp unit slided to the
(4) Insert new lamp unit into the LCD module and install the lamp unit until the hook a and b is engaged.
2) Adjusting volume have been set optimally before shipment, so do not change any adjusted value.
3) Disassembling the module can cause permanent damage and should be strictly avoided.
4) Please be careful since image retention may occur when a fixed pattern is displayed for a long
5) If any problem occurs in relation to the description of this specification , it shall be resolved
(The hook of the lamp unit will be unhooked from the hook b of the module.)
direction which arrow X indicates.
If adjusted value is changed, the specification may not be satisfied.
time
through discussion with spirit of cooperation.