LQ150X1LGN2E Sharp Electronics, LQ150X1LGN2E Datasheet - Page 20
![no-image](/images/manufacturer_photos/0/6/602/sharp_electronics_sml.jpg)
LQ150X1LGN2E
Manufacturer Part Number
LQ150X1LGN2E
Description
Manufacturer
Sharp Electronics
Datasheet
1.LQ150X1LGN2E.pdf
(27 pages)
Specifications of LQ150X1LGN2E
Lead Free Status / Rohs Status
Compliant
10. Handling Precautions
a)
b)
c)
d)
e)
f)
g)
h)
i)
j)
k)
l)
m) Make sure the four mounting holes of the module are grounded sufficiently. Take electro-magnetic
n)
o)
p)
q)
r)
s)
t)
Please make it like. If stress is added, there is a possibility that circuit parts may be damaged.
Blow away dust on the polarizer with antistatic N
is sensitive.
It is recommended to peel off softly using the adhesive tape when soil or finger oil is stuck to the polarizer.
When unavoidable, wipe off carefully with a cloth for wiping lenses.
display quality.
ordinances or regulations for disposal.
twist.
care.
consideration when handling.
Peel the film off slowly , just before the use, with strict attention to electrostatic charges.
protective board over the LCD, be careful about the optical interface fringe etc. which degrades
display quality.
panel is used under such environment.
interference (EMI) into consideration.
stress or pressure when handling or installing the module; otherwise some of electronic parts on the PCBs
may be damaged.
electrical shock. When exchange lamps or service, turn off the power without tail.
issue, functional defect, etc. So, please avoid such design.
storage in the environment of oxidization or deoxidization gas and the use of such materials as reagent,
solvent, adhesive, resin, etc. which generate these gasses, may cause corrosion and discoloration of the
LCD modules.
processing.
Be sure to turn off the power supply when inserting or disconnecting the cable.
Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or
Since the front polarize is easily damaged, pay attention not to scratch it.
Since long contact with water may cause discoloration or spots, wipe off water drop immediately.
When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Handle with
Since CMOS LSI is used in this module, take care of static electricity and take the human earth into
Since there is a circuit board in the module back, stress is not added at the time of a design assembly.
Protection film is attached to the module surface to prevent it from being scratched .
The polarizer surface on the panel is treated with Anti-Glare for low reflection. In case of attaching
Do not expose the LCD panel to direct sunlight. Lightproof shade etc. should be attached when LCD
Blow off 'dust' on the polarizer by using an ionized nitrogen.
The module has some printed circuit boards (PCBs) on the back side. Take care to keep them form any
There are high voltage portions on the backlight and very dangerous. Careless touch may lead to
Observe all other precautionary requirements in handling components.
When some pressure is added onto the module from rear side constantly, it causes display non-uniformity
When handling LCD modules and assembling them into cabinets, please be noted that long-term
Cold cathode fluorescent lamp in LCD panel contains a small amount of mercury, please follow local
Be careful of a back light lead not to pull by force at the time of the wiring to an inverter, or line
2
blow. It is undesirable to wipe off because a polarizer
LD-18317A-17