PPC405EP-3LB200C Applied Micro Circuits Corporation, PPC405EP-3LB200C Datasheet - Page 49

• Manufacturer Part Number: PPC405EP-3LB200C
• Manufacturer: Applied Micro Circuits Corporation

Specifications of PPC405EP-3LB200C

• Family Name: 405EP
• Device Core: PowerPC
• Device Core Size: 32b
• Frequency (max): 200MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 1.8V
• Operating Supply Voltage (max): 1.95V
• Operating Supply Voltage (min): 1.65V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 385
• Package Type: EBGA
• Lead Free Status / Rohs Status: Compliant

PPC405EP – PowerPC 405EP Embedded Processor
Initialization
The following describes the method by which initial chip settings are established when a system reset occurs.
Strapping
When the SysReset input is driven low (system reset), the state of certain I/O pins is read to enable default initial
conditions prior to PPC405EP start-up. The actual capture instant is the nearest system clock edge before the
deassertion of reset. These pins must be strapped using external pull-up (logical 1) or pull-down (logical 0)
resistors to select the desired default conditions. The recommended pull-up is 3kΩ to +3.3V or 10kΩ to +5V. The
recommended pull-down is 1KΩ to GND. These pins are use for strap functions only during reset. They are used
for other signals during normal operation. The following table lists the strapping pins along with their functions and
strapping options. The signal names assigned to the pins for normal operation appear below the pin number.
Table 16. Strapping Pin Assignments
EEPROM
During reset, configuration values other than the internal default values can be read from a serial EEPROM
connected to the IIC port. The association of bits in the EEPROM with the configuration values and their default
values are covered in detail in the PowerPC 405EP Embedded Processor User’s Manual.
Note: If P04 is strapped to 1, and the EEPROM is not connected or is defective, the PPC405EP remains in the
reset state and will not boot.
AMCC
IIC EEPROM controller
If the controller is enabled, 32 bytes of configuration data
are read from the EEPROM.
EEPROM address (P04 = 1)
or
Boot ROM width (P04 = 0)
When P04 = 1, these pins set the high-order two
bits of the EEPROM base address.
When P04 = 0, these pins indicated the width of
the boot ROM.
Function
High order EEPROM base address bits
reserved
reserved
Disable
Option
Enable
16 bits
8 bits
Revision 1.08 – March 24, 2008
UART0_RTS
UART0_Tx
Address bit
P04
N02
0
1
1
1
0
0
Ball Strapping
Data Sheet
Address bit
SysErr
Y17
0
1
0
1
49