S102S01 Sharp Electronics, S102S01 Datasheet - Page 9

• Manufacturer Part Number: S102S01
• Manufacturer: Sharp Electronics

Specifications of S102S01

• Input Type: DC
• Output Type: AC
• Input Voltage (max): 1.4V
• Output Voltage (max): 400V
• Input Current (max): 50mA
• Output Current: 8A
• Isolation Voltage: 4kV
• Package Type: SIP
• Output Device: Triac
• Pin Count: 4
• Mounting: Through Hole
• Operating Temp Range: -25C to 100C
• Operating Temperature Classification: Commercial
• Rad Hardened: No
• Lead Free Status / Rohs Status: Not Compliant

● Degradation
● Standard Circuit
✩ For additional design assistance, please review our corresponding Optoelectronic Application Notes.
Silicone grease to be used is as follows;
1) There is no aged deterioration within the operating temperature ranges.
2) Base oil of grease is hardly separated and is hardly permeated in the device.
3) Even if base oil is separated and permeated in the device, it should not degrade the function of a device.
Recommended grease : G-746 (Shin-Etsu Chemical Co., Ltd.)
In case the optional heat sink is screwed up, please solder after screwed.
In case of the lead frame bending, please keep the following minimum distance and avoid any mechanical
stress between the base of terminals and the molding resin.
Some of AC electromagnetic counters or solenoids have built-in rectifier such as the diode.
In this case, please use the device carefully since the load current waveform becomes similar with rectangu-
lar waveform and this results may not make a device turn off.
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
+V
V
CC
1
Tr1
: G-747 (Shin-Etsu Chemical Co., Ltd.)
: SC102 (Dow Corning Toray Silicone Co., Ltd.)
R
1
D
1
3
4
S102S01
S202S01
SSR
1
2
Z
9
Z
S
S
: Surge absorption circuit (Snubber circuit)
Load
4.4mm MIN.
AC Line
S102S01 Series
S202S01 Series
Sheet No.: D4-A02301EN