EVAL-ADT7310EBZ Analog Devices Inc, EVAL-ADT7310EBZ Datasheet - Page 10

• Manufacturer Part Number: EVAL-ADT7310EBZ
• Manufacturer: Analog Devices Inc

Specifications of EVAL-ADT7310EBZ

• Lead Free Status / Rohs Status: Supplier Unconfirmed

ADT7310
ONE-SHOT MODE
Setting Bit 5 to 1 and Bit 6 to 0 of the configuration register
(Register Address 0x01) enables the one-shot mode. When
this mode is enabled, the ADT7310 immediately completes a
conversion and then goes into shutdown mode.
Wait for a minimum of 240 ms after writing to the one-shot
bits before reading back the temperature from the temperature
value register. This time ensures that the ADT7310 has time to
power up and complete a conversion.
The one-shot mode is useful when one of the circuit design
priorities is to reduce power consumption.
DOUT
SCLK
DIN
CS
Figure 14. Typical SPI One-Shot Write to Configuration Register Followed by a Read from the Temperature Value Register
0x08
0x20
Rev. 0 | Page 10 of 24
FOR CONVERSION TO FINISH
WAIT 240ms MINIMUM
1 SPS MODE
In this mode, the part performs one measurement per second.
A conversion takes only 60 ms, and it remains in the idle state
for the remaining 940 ms period. This mode is enabled by
writing 0 to Bit 5 and 1 to Bit 6 of the configuration register
(Register Address 0x01).
DATA