JKXEP0G07FPSDP Souriau Connection Technology, JKXEP0G07FPSDP Datasheet - Page 3

• Manufacturer Part Number: JKXEP0G07FPSDP
• Description: Circular Push Pull Connectors PUSH-PULL CONNECTOR
• Manufacturer: Souriau Connection Technology
• Series: JKXr

Specifications of JKXEP0G07FPSDP

• Product Type: Connectors
• Number Of Contacts: 7
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Rev 1 – April 14, 2004
5. If inserting removable contacts:
b. If using soldered contacts, prep each wire with flux and then tin dip each exposed
a. Starting with the interface end of the contact, carefully insert each contact into the
Locator Pin and Socket .07-.09 mm and 1.3 mm contacts
wire end. Next pre-load a piece of heat shrink onto the wire (Individual heat
shrink tubes are optional). Solder each wire to the solder cup end of the contact.
To avoid shorts, make sure that no solder comes in contact with any other contact
or wire on the connector. After the contact has been soldered to the wire, check
each contact to insure that the contact is securely soldered to the wire. Slide the
pre-loaded heat shrink over the solder joint and shrink into place. Do not over-
heat the solder joint area as it can cause the solder to re-flow or it could burn the
wire insulation.
backside of the insulator that has the position loading path indicator (worm) on it.
Start with the end of the position loading path indicator (worm) that has the half
circle on it (Position #1). Then follow the position loading path indicator (worm)
around the insulator. You will go counter clockwise if using a male contact and
clockwise if using a female contact (see diagram below for the position loading
path indicator (worm) layout). If the connector has center contacts, it is sometimes
easier to start at the end of the position loading path indicator (worm) (last
position) and work backwards. This is up to the assembler and the process they
are using to insert the contacts. Make sure not to bend the contact when inserting
it into the insulator. It is extremely important that the contact is completely seated
in to the insulator. For the connector to function properly, the contact should
click/snap into place when seated. To confirm the seating of the contact, check
each contact for proper seating.
Turret with locator for pin and socket 1.6 mm and 2 mm contacts