20-101-0673 Rabbit Semiconductor, 20-101-0673 Datasheet - Page 34

• Manufacturer Part Number: 20-101-0673
• Description: MODULE RABBITCORE RCM3610
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0673

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Core Processor: Rabbit 3000
• Clock Speed: 22.1 MHz
• Interface Type: Serial
• Flash: 256 KB
• Timers: 10 x 8 bit, 1 x 10 bit
• Operating Supply Voltage: 3 V to 3.6 V
• Board Size: 31 mm x 54 mm x 16 mm
• Core: RCM3610
• Processor Series: RCM3600
• For Use With/related Products: RCM3610
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1103

4.2.2 Serial Programming Port
The RCM3600 programming port is accessed through header J2 or over an Ethernet con-
nection via the RabbitLink EG2110. The programming port uses the Rabbit 3000’s Serial
Port A for communication. Dynamic C uses the programming port to download and debug
programs.
The programming port is also used for the following operations.
• Cold-boot the Rabbit 3000 on the RCM3600 after a reset.
• Remotely download and debug a program over an Ethernet connection using the
• Fast copy designated portions of flash memory from one Rabbit-based board (the
Alternate Uses of the Programming Port
All three clocked Serial Port A signals are available as
• a synchronous serial port
• an asynchronous serial port, with the clock line usable as a general CMOS input
The serial programming port may also be used as a serial port via the
the serial programming cable.
In addition to Serial Port A, the Rabbit 3000 startup-mode (SMODE0, SMODE1), status,
and reset pins are available on the programming port.
The two startup mode pins determine what happens after a reset—the Rabbit 3000 is
either cold-booted or the program begins executing at address 0x0000.
The status pin is used by Dynamic C to determine whether a Rabbit microprocessor is
present. The status output has three different programmable functions:
1. It can be driven low on the first op code fetch cycle.
2. It can be driven low during an interrupt acknowledge cycle.
3. It can also serve as a general-purpose CMOS output.
The reset pin is an external input that is used to reset the Rabbit 3000. The serial program-
ming port can be used to force a hard reset on the RCM3600 by asserting the reset signal.
Refer to the
28
RabbitLink EG2110.
master) to another (the slave) using the Rabbit Cloning Board.
Rabbit 3000 Microprocessor User’s Manual
for more information.
DIAG
RabbitCore RCM3600
connector on