101-0521 Rabbit Semiconductor, 101-0521 Datasheet - Page 60

• Manufacturer Part Number: 101-0521
• Description: MODULE RABBITCORE RCM3210
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0521

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3210
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 101-521; 101-521

6.5 Run the PINGME.C Sample Program
Connect the crossover cable from your computer’s Ethernet port to the RCM3200 board’s
RJ-45 Ethernet connector. Open this sample program from the
folder, compile the program, and start it running under Dynamic C. When the program
starts running, the green
Ethernet connection is made. (Note: If the
crossover cable, or if you are using a hub perhaps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the pingme program:
or by
and typing the entry
Notice that the red
place, and indicates the transfer of data. The ping routine will ping the board four times
and write a summary message on the screen describing the operation.
6.6 Running More Sample Programs With Direct Connect
The sample programs discussed here are in the Dynamic C
folder.
•
•
•
•
54
BROWSELED.C
Two “LEDs” are created on the Web page, and two buttons on the Prototyping Board
then toggle them. Users can change the status of the lights from the Web browser. The
LEDs on the Prototyping Board match the ones on the Web page. As long as you have
not modified the
address in your Web browser to bring up the Web page served by the sample program.
Otherwise use the TCP/IP settings you entered in the
ECHOCLIENT.C
wait for the connected server to echo it back. After every number of sends and receives,
transfer times are shown in the
Use
ECHOSERVER.C
data sent from a connected client.
Use
ENET_AD.C
single-board computers. The program sends an A/D voltage value to the second single-
board computer via Ethernet for display.
Use
http://10.10.6.100.
Start > Run
ping 10.10.6.100
ping 10.10.6.100
ECHO_SERVER.C
ECHO_CLIENT.C
ENET_MENU.C
—This program demonstrates Ethernet communication between two
—This program demonstrates a basic controller running a Web page.
ACT
—This program demonstrates a basic client that will send a packet and
—This program demonstrates a basic server that will echo back any
TCPCONFIG 1
to program the other single-board computer.
light flashes on the RCM3200 board while the ping is taking
LNK
to program a server controller.
to program a client controller.
light on the RCM3200 board should be on to indicate an
STDIO
macro in the sample program, enter the following server
window.
LNK
light does not light, you may not have a
TCP_CONFIG.LIB
SAMPLES\RCM3200\TCPIP\
SAMPLES\TCPIP\ICMP
RabbitCore RCM3200
library.