101-1006 Rabbit Semiconductor, 101-1006 Datasheet - Page 110

• Manufacturer Part Number: 101-1006
• Description: MODULE POWERCORE FLEX 3800
• Manufacturer: Rabbit Semiconductor

Specifications of 101-1006

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3800
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6.5 Run the PINGME.C Sample Program
Connect the crossover cable from your computer’s Ethernet port to the PowerCore module’s
RJ-45 Ethernet connector. Open this sample program from the
folder, compile the program, and start it running under Dynamic C. The crossover cable is
connected from your computer’s Ethernet adapter to the PowerCore module’s RJ-45
Ethernet connector. When the program starts running, the green DS2 LED on the Power-
Core module should be on to indicate an Ethernet connection is made. (Note: If the green
LED does not light, you may not be using a crossover cable, or if you are using a hub per-
haps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the pingme program:
or by
and typing the entry
Notice that the yellow DS1 LED flashes on the PowerCore module while the ping is tak-
ing place, and indicates the transfer of data. The ping routine will ping the board four
times and write a summary message on the screen describing the operation.
6.6 Running Additional Sample Programs
Many generic TCP/IP sample programs are available in the Dynamic C
folder. The following sample programs specific to the PowerCore FLEX modules are in
the Dynamic C
•
•
102
SMTP.c
either switch S2 or S3 on the Prototyping Board is pressed. If you are using a direct
connection, you will need an SMTP server on your host machine.
SSI.c
(LED0 and LED1) from the PowerCore Prototyping Board. Two “device LEDs” are
created along with two buttons to toggle them. Users can use their Web browser to
change the status of the LEDs to match the status on the Prototyping Board.
As long as you have not modified the
enter the following server address in your Web browser to bring up the Web page
served by the sample program.
Otherwise use the TCP/IP settings you entered in the
http://10.10.6.100.
Start > Run
ping 10.10.6.101
ping 10.10.6.101
—This program demonstrates using a Web page to control LEDs DS5 and DS6
—This program demonstrates using the SMTP library to send an e-mail when
SAMPLES\PowerCoreFLEX\TCPIP\
TCPCONFIG 1
folder.
TCP_CONFIG.LIB
macro in the sample program,
SAMPLES\TCPIP\ICMP
SAMPLES\TCPIP
PowerCore FLEX
library.