101-0526 Rabbit Semiconductor, 101-0526 Datasheet - Page 133

• Manufacturer Part Number: 101-0526
• Description: COMPUTER SNGLBD LP3510 FOX7.4MHZ
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0526

• Module/board Type: Single Board Computer Module
• For Use With/related Products: LP3510
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

E.2.3 Reset Generator
The LP3500 module uses a reset generator on the module, U11, to reset the Rabbit 3000
microprocessor when the voltage drops below the voltage necessary for reliable operation.
The reset occurs between 2.55 V and 2.75 V, typically 2.63 V.
E.3 Chip Select Circuit
The current drain on the battery in a battery-backed circuit must be kept at a minimum.
When the LP3500 is not powered, the battery keeps the SRAM memory contents and the
real-time clock (RTC) going. The SRAM has a powerdown mode that greatly reduces
power consumption. This powerdown mode is activated by raising the chip select (CS)
signal line. Normally the SRAM requires Vcc to operate. However, only 2 V is required
for data retention in powerdown mode. Thus, when power is removed from the circuit, the
battery voltage needs to be provided to both the SRAM power pin and to the CS signal
line. The CS control circuit accomplishes this task for the SRAM’s chip select signal line.
In a powered-up condition, the CS control circuit must allow the processor’s chip select
signal /CS1 to control the SRAM’s CS signal /CSRAM. So, with power applied, /CSRAM
must be the same signal as /CS1, and with power removed, /CSRAM must be held high
(but only needs to be battery voltage high).The isolated /CSRAM line has a 220 kΩ pullup
resistor to VRAM (R46). This pullup resistor keeps /CSRAM at the VRAM voltage level
(which under no power condition is the backup battery’s regulated voltage at a little more
than 2 V).
User’s Manual
127