20-101-0654 Rabbit Semiconductor, 20-101-0654 Datasheet - Page 50

• Manufacturer Part Number: 20-101-0654
• Description: INTERFACE OP6800 512K FLASH&SRAM
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0654

• Module/board Type: Single Board Computer Module
• Product: Modules
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Backup Battery: Lithium Battery
• Operating Voltage: 9 V to 36 V
• Power Consumption: 1.5 W
• Board Size: 111 mm x 91 mm x 33 mm
• Description/function: Computer Module
• For Use With/related Products: OP6800
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-654; 20-101-654

6.2 Mounting Instructions
A bezel and a gasket are included with the OP6800. When properly mounted in a panel,
the bezel of the OP6800 is designed to meet NEMA 4 specifications for water resistance.
Since the OP6800 employs an LCD display, the viewing angle must be considered when
mounting the display. Install the OP6800 at a height and angle that makes it easy for the
operator to see the screen.
6.2.1 Bezel-Mount Installation
This section describes and illustrates how to bezel-mount the OP6800. Follow these steps
for bezel-mount installation.
1. Cut mounting holes in the mounting panel in accordance with the recommended dimen-
2. Remove the standoffs added to the OP6800 as described in Chapter 2, “Getting
3. Carefully “drop in” the OP6800 with the bezel and gasket attached.
46
sions in Figure 20, then use the bezel faceplate to mount the OP6800 onto the panel.
Started.” The standoffs were used to prop up the OP6800 beside the Demonstration
Board, and are not needed to mount the OP6800.
Figure 20. Recommended Cutout Dimensions
MiniCom (OP6800)