101-0303 Rabbit Semiconductor, 101-0303 Datasheet - Page 22

• Manufacturer Part Number: 101-0303
• Description: SMARTSCREEN OP7100 DISPLAY
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0303

• Module/board Type: Single Board Computer Module with display
• For Use With/related Products: Single Board Computers
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

Running Dynamic C
Double-click the Dynamic C icon to start the software. Note that the PC
attempts to communicate with the OP7100 each time Dynamic C is started.
No error messages are displayed once communication is established.
The communication rate, port, and protocol are all selected by choosing
Serial Options
OP7100 both set their baud rate automatically to match the communication
rate set on the host PC using Dynamic C (9600 bps, 19,200 bps, 28,800 bps,
or 57,600 bps). To begin, adjust the communications rate to 19,200 bps.
Make sure that the PC serial port used to connect the serial cable (COM1
or COM2) is the one selected in the Dynamic C
the 1-stop-bit protocol.
At this point, the LCD should be blank and the backlight should be off.
Once communication is established, load the sample program
DEFDEMOL.C
and run the program by pressing
menu.
The OP7100 should now alternately display the large font (17x × 35h) and
the small font (6w × 8h). The fonts should scroll across the display.
22 Getting Started
See Appendix A, “Troubleshooting,” if an error message such
as
Once the necessary changes have been made to establish
communication between the host PC and the OP7100, use the
Dynamic C shortcut
communication.
Compiling and running this sample program will overwrite the
demonstration program shown in Figure 2-3.
in the Dynamic C
Target Not Responding
from Dynamic C’s
SAMPLES\QVGA
<Ctrl Y>
F9
OPTIONS
or by selecting
or
to reset the controller and initiate
Communication Error
menu. The SIB and the
OPTIONS
subdirectory. Compile
Run
from the
menu. Select
Run
appears.
OP7100