101-0303 Rabbit Semiconductor, 101-0303 Datasheet - Page 44

• Manufacturer Part Number: 101-0303
• Description: SMARTSCREEN OP7100 DISPLAY
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0303

• Module/board Type: Single Board Computer Module with display
• For Use With/related Products: Single Board Computers
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

The serial ports can be polled or interrupt-driven.
A polling driver tests the ready flags (TDRE and RDRF) until a ready
condition appears (transmitter data register empty or receiver data register
full). If an error condition occurs on receive, the routine must clear the
error flags and take appropriate action, if any. If the
flow control, transmission of data is automatically stopped when
goes high because the TDRE flag is disabled. This prevents the driver from
transmitting more characters because it thinks the transmitter is not ready.
The transmitter will still function with
because TDRE is not available to synchronize loading the data register
(TDR) properly.
An interrupt-driven port works as follows. The program enables the
receiver interrupt as long as it wants to receive characters. The transmitter
interrupt is enabled only while characters are waiting in the output buffer.
When an interrupt occurs, the interrupt routine must determine the cause:
receiver data register full, transmitter data register empty, receiver error, or
/DCD0
triggered. Another interrupt will occur immediately if interrupts are re-
enabled without disabling the condition causing the interrupt. The signal
/DCD0
Table 3-3 lists the interrupt vectors.
44 Hardware
Address
0E
10
pin high (channel 0 only). None of these interrupts is edge-
is grounded on the OP7100.
SER0_VEC
SER1_VEC
Table 3-3. Serial Port Interrupt Vectors
Name
Z180 Serial Port 0 (higher priority)
Z180 Serial Port 1
/CTS
high, but exercise care
Description
/CTS
line is used for
/CTS
OP7100