SB72EX-100CR NetBurner Inc, SB72EX-100CR Datasheet - Page 9

• Manufacturer Part Number: SB72EX-100CR
• Description: DUAL PORT SERIAL-ETHERNET
• Manufacturer: NetBurner Inc

Specifications of SB72EX-100CR

• Module/board Type: Ethernet Board
• For Use With/related Products: SB72
• For Use With: 528-1000 - KIT DEV SERIAL-ETHERNET FOR SB72
• Other names: Q2999326

Device Connection Settings (UDP mode)
Return to the Network section by clicking on the Network link directly above the Advanced Serial section.
Click on the Switch to UDP mode link,(directly under your SB72EX settings) to go to the UDP section.
You will see “System is set to UDP mode” after you click the Switch to UDP mode link
When you are finished with this section, click the appropriate button at the bottom. Submit New Settings
will save your settings, and Reset to Factory Defaults will restore the factory values. Enter your valid
destination IP address as a numeric address separated by periods. Remember, if you are only using one
port, you can ignore the other port’s section.
SB72EX User's Manual, 350030-001
Page 9