PMJ5918TSR Ericsson Power Modules, PMJ5918TSR Datasheet - Page 23

DC/DC Converters & Regulators 0.8-3.6V 30A Non-Iso Input 5V 108W

PMJ5918TSR

Manufacturer Part Number
PMJ5918TSR
Description
DC/DC Converters & Regulators 0.8-3.6V 30A Non-Iso Input 5V 108W
Manufacturer
Ericsson Power Modules
Series
PMJr
Datasheet

Specifications of PMJ5918TSR

Product
Non-Isolated / POL
Output Power
108 W
Input Voltage Range
4.5 V to 5.5 V
Number Of Outputs
1
Output Voltage (channel 1)
0.8 V to 3.6 V
Output Current (channel 1)
30 A
Output Type
POLA Non-Isolated Regulator
Lead Free Status / Rohs Status
Lead free / RoHS Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
PMJ5918TSR
Manufacturer:
ERICSSON
Quantity:
12 000
EMC Specification
Conducted EMI measured according to test set-up.
The fundamental switching frequency is 300 kHz for
PMJ 5918T @ V
Conducted EMI Input terminal value (typ)
EMI without filter
Test set-up
Layout recommendation
The radiated EMI performance of the DC/DC regulator will
depend on the PCB layout and ground layer design.
It is also important to consider the stand-off of the DC/DC
regulator.
If a ground layer is used, it should be connected to the output
of the DC/DC regulator and the equipment ground or chassis.
A ground layer will increase the stray capacitance in the PCB
and improve the high frequency EMC performance.
Prepared (also subject responsible if other)
SEC/D KEVIN YAN
Approved
SEC/D Wei Zhang A
PMJ 5000 series
POL regulator, Input 4.5-5.5 V, Output 30 A/108 W
I
= 5.0 V, max I
TBD
TBD
O
.
Checked
PRODUCT SPEC.
No.
3/1301-BMR 646 5 Uen
Date
2006-2-8
Output ripple and noise
Output ripple and noise measured according to figure below.
See Design Note 022 for detailed information.
Output ripple and noise test setup
Operating information
Extended information for POLA products is found in
Application Note POLA.
Input Voltage
The input voltage range 4.50 to 5.50 Vdc makes the product
easy to use in intermediate bus applications when powered
by a regulated bus converter.
Turn-off Input Voltage
The DC/DC regulators monitor the input voltage and will turn
on and turn off at predetermined levels.
The minimum hysteresis between turn on and turn off input
voltage is 50mV.
Remote Control (RC) Inhibit
The regulator will turn on when the input voltage is applied
with the INHIBIT pin open. Turn off is achieved by connecting
the INHIBIT pin to the - In. To ensure safe turn off, the voltage
difference between INHIBIT pin and the - In pin shall be less
than 0.6V. The regulator will restart automatically when this
connection is opened.
Technical Specifi cation
EN/LZT 146 326 R1B April 2006
© Ericsson Power Modules AB
Rev
A
The products are fitted with a
remote control function referenced
to the primary negative input
connection (- In), positive logic. The
INHIBIT function allows the
regulator to be turned on/off by an
external device like a
semiconductor or mechanical
switch. The INHIBIT pin has an
internal pull up resistor to + In.
Reference
1 (5)
23

Related parts for PMJ5918TSR