STBVP6-RB1E02 BANNER ENGINEERING, STBVP6-RB1E02 Datasheet - Page 3

• Manufacturer Part Number: STBVP6-RB1E02
• Description: Safety; Duo-Touch; Run Bar System; LED Indicator; 2 NC Safety Contacts
• Manufacturer: BANNER ENGINEERING

Specifications of STBVP6-RB1E02

• Function: Proximity
• Primary Type: Photoelectric
• Sensing Mode: Through-Beam
• Technology: Photoelectric

Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
The DUO-TOUCH
to satisfy the ergonomic principles found in ANSI B11.TR1 to reduce the hand, wrist, and
arm stresses associated with mechanical push buttons. The rugged 13-ga. steel housing
is designed to prevent inadvertent switch actuation due to objects (such as loose clothing
or debris) which might accidentally block the sensing beam.
The STB Touch Buttons are touch-activated photoelectric devices designed to replace
capacitive touch switches and mechanical push buttons. Their outputs activate when a
finger is present in the yoke (“touch area”) of the switch, interrupting the button’s infrared
sensing beam. These “buttons” require absolutely no physical pressure to operate, and
are immune to EMI, RFI, and ambient light interference (see specifications on page 10).
The STB button’s internal design incorporates dual microcontrollers, allowing hookup to
a Banner DUO-TOUCH SG Two-Hand Control Safety Module (or other two-hand control
systems designed to meet Type IIIC requirements per ISO 13851 (EN 574), and ISO
13849-1 category 4 requirements).
The microcontrollers in the STB buttons perform a continuous self-check: the
emitter is continuously pulsed, and receiver response is checked accordingly by the
microcontrollers. STB touch buttons are designed to immediately detect any internal
component failure, go into lockout mode, and indicate the failure with a flashing red Fault
LED.
STB Series Touch Button LED Indicators
Power On (green): Steady ON when power is applied
Output, Fault (green): Steady ON when button is activated
DUO-TOUCH
®
Run Bar with STB Self-Checking Optical Touch Buttons is designed
OFF when button is not activated
Flashing when a fault condition is detected
®
Run Bar with STB Buttons
Description
P/N 131634 rev. B
3