WLNG-EK-DP551 Quatech, WLNG-EK-DP551 Datasheet - Page 41
![no-image](/images/no-image-200.jpg)
WLNG-EK-DP551
Manufacturer Part Number
WLNG-EK-DP551
Description
WiFi / 802.11 Modules & Development Tools AIRBORNE EVAL KIT EMBEDDED MODULES
Manufacturer
Quatech
Series
Airborne™r
Type
Transceiver, 802.11 b/gr
Datasheets
1.WLNG-AN-DP551.pdf
(2 pages)
2.WLNG-EK-DP551.pdf
(8 pages)
3.WLNG-EK-DP551.pdf
(62 pages)
Specifications of WLNG-EK-DP551
Mfg Application Notes
Transition to DP550 Devices AppNote
Frequency
2.4GHz ~ 2.4835GHz
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With/related Products
Airborne Modules
Quatech, Inc.
100-8082-110
8.3
8.4
8.5
Determine and Store the Access Point SSID
On the Host computer, use the terminal emulation program to type the following
CLI commands in the order shown:
If your access point has security enabled, you will also need to use the CLI to
enter those parameters (See the Enterprise CLI Reference Guide for details).
That setup is outside the scope of this user guide, which assumes that the AP
being tested with has no security.
After issuing the commands, press the reset switch (SW2) on the EVB. The EVB
restarts and the RF_ACT LED blinks to show that the module is searching for an
AP. Once the module has found and associated to the AP entered using the wl-
ssid command the RF_ACT LED will turn on continuously.
Determine the Module’s IP address
On the Host computer, use the terminal emulation program to type the following
CLI commands:
Accessing the Module Using Telnet
On the Remote computer, use HyperTerminal to start a Telnet session. In the
first screen, name the session ‘TCP <Module IP>’ (for reference purposes only),
click on any icon you want to associate with this Telnet session, and click OK. In
the next screen, click TCP/IP (Winsock) for Connect Using. In the Host Address
field, type the module’s IP address. Leave the default Port Number value of 23
and click OK.
The HyperTerminal application will then attempt to open a TCP session with the
module, Connecting is shown in the status bar at the bottom-left side of the
CLI Command
wl-scan<CR>
wl-ssid [SSID]<CR>
commit<CR>
CLI Command
auth dpac dpac <CR>
wl-ip<CR>
Airborne Enterprise EVB Users Guide
Table 43 - UART Determine Module's IP Address
Table 42 - UART SSID & Authentication
Description
The module scans for APs and returns information on
each one it discovers. Note the SSID value that is
returned, as you will need to enter it in the next
command
Associates the module with the AP whose [SSID] you
specify. [SSID] is the value returned by the wl-scan
command.
Stores the information to flash memory.
Description
Authenticate with the device server.
The module returns the IP address assigned to it by
the DHCP server.
41