SX8661I07AULTRT Semtech, SX8661I07AULTRT Datasheet - Page 22
![no-image](/images/manufacturer_photos/0/5/595/semtech_sml.jpg)
SX8661I07AULTRT
Manufacturer Part Number
SX8661I07AULTRT
Description
IC, Capacitive Button Touch And Proximity Controller, 8 SENSOR, MLPQ-28
Manufacturer
Semtech
Datasheet
1.SX8661I07AULTRT.pdf
(88 pages)
Specifications of SX8661I07AULTRT
Controller Type
Capacitive Touch Screen
Ic Interface Type
I2C
Supply Voltage Range
2.7V To 3.6V
Operating Temperature Range
-40°C To +85°C
SX8661
Low Power, Capacitive Button Touch and Proximity Controller
(8 sensors) with LED Drivers and Analog Output
ADVANCED COMMUNICATIONS & SENSING
DATASHEET
Analog Sensor Interface
Figure 18
To get the ticks representing the charge on a specific sensor the ASI will execute several steps.
The charge on a sensor cap (e.g CAP0) will be accumulated multiple times on the external integration capacitor,
Cint.
This results in an increasing voltage on Cint proportional to the capacitance on CAP0.
At this stage the offset compensation DAC is enabled. The compensation DAC generates a voltage proportional
to an estimation of the external capacitance. The estimation is obtained by the offset compensation procedure
executed e.g. at power-up.
The difference between the DAC output and the charge on Cint is the desired signal. In the ideal case the
difference of charge will be converted to zero ticks if no finger is present and the number of ticks becomes high in
case a finger is present.
The difference of charge on Cint and the DAC output will be transferred to the ADC (Sigma Delta Integrator).
After the charge transfer to the ADC the steps above will be repeated.
The larger the number the cycles are repeated the larger the signal out of the ADC with improved SNR. The
sensitivity is therefore directly related to the number of cycles.
The SX8661 allows setting the sensitivity for each sensor individually in applications which have a variety of
sensors sizes or different overlays or for fine-tuning performances. The optimal sensitivity is depending heavily on
the final application. If the sensitivity is too low the ticks will not pass the thresholds and touch/proximity detection
will not be possible. In case the sensitivity is set too large, some power will be wasted and false touch/proximity
information may be output (i.e. for touch buttons => finger not touching yet, for proximity sensors => finger/hand
not close enough).
Once the ASI has finished the first sensor, the ticks are stored and the ASI will start measuring the next sensor
until all (enabled) sensors pins have been treated.
In case some sensors are disabled then these result in lower power consumption simply because the ASI is active
for a shorter period and the following processing period will be shorter.
The ticks from the ASI will then be handled by the digital processing.
The ASI will shut down and wait until new sensing period will start.
Revision v3.2, January 2011
© 2011 Semtech Corp.
www.semtech.com
22