SX8661I07AULTRT Semtech, SX8661I07AULTRT Datasheet - Page 77

• Manufacturer Part Number: SX8661I07AULTRT
• Description: IC, Capacitive Button Touch And Proximity Controller, 8 SENSOR, MLPQ-28
• Manufacturer: Semtech

Specifications of SX8661I07AULTRT

• Controller Type: Capacitive Touch Screen
• Ic Interface Type: I2C
• Supply Voltage Range: 2.7V To 3.6V
• Operating Temperature Range: -40°C To +85°C

ADVANCED COMMUNICATIONS & SENSING
6.6.2
The SPM must always be read in blocks of 8 bytes. The sequence is described below:
The complete SPM can be read by repeating 16 times the cycles shown in Figure 59 using base addresses 0x00,
0x08, 0x10,…0x70, 0x78.
Once the SPM read sequence is actually applied, the INTB pin will be asserted. The host clears the interrupt by
reading any I2C register. At the same time the bit GenStatMsb[6], indicating the SPM write is done, will be
cleared.
Revision v3.2, January 2011
1. Set the I2C in SPM mode by writing “01” to SpmCfg[5:4] and SPM read access by writing ‘1’ to SpmCfg[3].
2. Write the SPM base address to SpmBaseAddr (The base address needs to be a value modulo 8).
3. Read the eight consecutive bytes from I2C address 0, 1, 2, …7
4. Terminate by writing “000” to SpmCfg[5:3].
SPM Read Sequence
Low Power, Capacitive Button Touch and Proximity Controller
Figure 59
© 2011 Semtech Corp.
SPM Read Sequence
77
(8 sensors) with LED Drivers and Analog Output
www.semtech.com
DATASHEET
SX8661