R88A-TK07W Omron, R88A-TK07W Datasheet - Page 174

no-image

R88A-TK07W

Manufacturer Part Number
R88A-TK07W
Description
BRACKET
Manufacturer
Omron
Datasheet

Specifications of R88A-TK07W

Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
R88ATK07W
3-18
System Design and Installation
2.Strip the covering off the ends of the wires.
3.Open the wire insertion slots in the Terminal Block
4.Insert the wire into the slot.
5.Mount the Terminal Block to the Servo Driver.
Prepare wires of the right sizes, according to the tables provided under Terminal Block Wire Sizes
above, and strip off 8 or 9 mm of the covering from the end of each wire.
There are two ways to open the wire insertion slots, as follows:
With the slot held open, insert the end of the wire. Then let the slot close by releasing the pressure
from the lever or the screwdriver.
After all of the terminals have been wired, return the Terminal Block to its original position on the
Servo Driver.
• Pry the slot open using the lever that comes with the Servo Driver (as in Fig. A).
• Insert a flat-blade screwdriver (end width: 3.0 to 3.5 mm) into the opening for Servo Driver in-
stallation, and press down firmly to open the slot (as in Fig. B).
Fig. A
8 to 9 mm
231-131 Lever
(Wago Company
of Japan)
Fig. B
210-120J Driver
(Wago Company
of Japan)
Chapter 3