3F88L-CR002C Omron, 3F88L-CR002C Datasheet - Page 141
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
3F88L-CR002C
Manufacturer Part Number
3F88L-CR002C
Description
CABLE RESOLVER FOR RS17/T 2M
Manufacturer
Omron
Datasheet
1.3F88L-RL10.pdf
(232 pages)
Specifications of 3F88L-CR002C
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
3F88LCR002C
- Current page: 141 of 232
- Download datasheet (5Mb)
Operation
Recommended Products
Note Keep the RS-232C cable under 5 m.
H Outline of Data Transfer Operation
The basic operation when transferring data (cam programs and parameters) between two Cam Posi-
tioner Units is outlined below.
RS-232C
Connector
Cable
1. Connect the RS-232C Cable.
2. Set the baud rate.
3. Turn OFF the power supply and turn it ON again.
4. Put the Slave Unit into transmission enabled mode.
5. Put the Master Unit into transmission enabled mode.
Name
Connect the cable according to the instructions under Connecting RS-232C Cables in the previous
section.
Set the baud rate (Function No. b, Parameter No. 6). Set the same baud rate for both Master and
Slave Units.
1: 9,600 bps (factory setting)
2: 19,200 bps
If the baud rate setting has been changed, turn OFF the power supply and turn it ON again. This will
enable the baud rate setting.
Display Function No. t, Parameter No. 0 on the Slave Cam Positioner Unit.
Display Function No. t, Parameter No. 1 on the Master Cam Positioner Unit. Set the data as required
for the transmission and press the Set Key. The data transfer will begin.
1: Data read (Reads programs and parameters from the Slave to the Master.)
2: Data write (Writes programs and parameters from the Master to the Slave.)
3: Data verification (Verifies the Master programs and parameters against the Slave programs and
parameters.)
XM2D-0901 (OMRON)
XM2S-0913 (OMRON)
Non-UL
product
UL product UL2464 AWG28×5P IFS-RVV-SB (Fujikura
d
AWG28×5P IFVV-SB (Fujikura Ltd.)
CO-MA-VV-SB 5P×28AWG (Hitachi Cable,
Ltd.)
Ltd.)
UL2464-SB (MA) 5P×28AWG (Hitachi
Cable, Ltd.)
Model (manufacturer)
2
2
1
No. of
Units
9-pin D-sub connector
(socket)
Connector hood
Shielded multi-con-
d
ductor cable
Description
Chapter 3
bl
3-89