XW2B-80J7-1A Omron, XW2B-80J7-1A Datasheet - Page 202
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
XW2B-80J7-1A
Manufacturer Part Number
XW2B-80J7-1A
Description
RELAY UNIT
Manufacturer
Omron
Datasheet
1.XW2Z-100J-C1.pdf
(414 pages)
Specifications of XW2B-80J7-1A
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
XW2B80J71A
- Current page: 202 of 414
- Download datasheet (20Mb)
Pulse Counter Timer Specifications
7-6-9
Pulse Outputs
Target-value Comparison Interrupts from Pulse Output PVs
An interrupt task can be executed when the pulse output PV reaches a target
value, although this function cannot be used in independent mode (position-
ing), one-shot pulse output operation mode, or electronic cam control
because the pulse output stops.
When the pulse output operation mode is set to linear mode, this function can
be used for speed control (frequency changes) based on the present position.
When the pulse output operation mode is set to circular mode, this function
can be used for continuous speed control to control a series of repetitive oper-
ations at specific positions by repeating speed control patterns.
The processing of the target-value comparison interrupts for pulse output PVs
is the same as the processing for high-speed counter PVs, so refer to Check-
ing for High-speed Counter Interrupts under High-speed Counter Function
Description in 7-5-8 Pulse Input Function Description for details.
Timer measurement
range
Operating conditions 1. Set the pulse output operation mode to Calculation (time
(3) If the STIM(980) instruction is executed again to restart an operating tim-
er, the timer value will be reset to 0 and the timer will restart.
Item
0000 0000 to FFFF FFFF hex
The time units can be set to 0.01 ms, 0.1 ms, or 1 ms with the
STIM(980) instruction.
2. To start or stop the timer, execute the STIM(980) instruction
measurement) in the System Setup.
with operand C1 = #000B or #000C and one of the following
C2 values:
To start the timer, execute STIM(980) with operand C2 =
#0000.
To stop the timer, execute STIM(980) with operand C2 =
#0001.
Specification
Section 7-6
179