SI2400-KS Silicon Laboratories Inc, SI2400-KS Datasheet - Page 54

• Manufacturer Part Number: SI2400-KS
• Description: IC ISOMODEM SYSTEM-SIDE 16SOIC
• Manufacturer: Silicon Laboratories Inc
• Type: Integrated Global DAAr

Specifications of SI2400-KS

• Package / Case: 16-SOIC (3.9mm Width)
• Data Format: V.21, V.22, V.23, Bell 103, Bell 212A
• Baud Rates: 2.4k
• Interface: UART
• Voltage - Supply: 3 V ~ 5.25 V
• Mounting Type: Surface Mount
• Product: Modem Chip
• Supply Voltage (min): 3 V
• Supply Current: 21 mA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With: 336-1166 - BOARD EVAL FOR SI2400 ISOMODEM
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 336-1093

Si2400
S14 (MF4). Modem Functions 4
Reset settings = 0000_0000
54
Name
Type
Bit
Bit
7
6
5
4
3
2
1
0
MRCD
R/W
D7
MRCD
Name
AOC
UDF
TEO
NLD
IND
OD
RD
UDF
R/W
D6
Disable Modem Result Codes. (See S62 also.)
0 = Enables the following modem result codes:
1 = Disables the following modem result codes:
Intrusion—”i” and “ I ”
Line present—”l” and “L”
Flash—”f”
Ring—”R”
Register S62 can be used to individually re-enable particular result codes.
User Defined Frequency.
0 = Disable.
1 = Enable user defined frequency detectors in A0 and !0 modes.
TIES Escape Operation.
0 = Disable TIES escape operation.
1 = Enable TIES.
AutoOverCurrent Detection.
0 = Disables AutoOverCurrent detection.
1 = Enables AutoOverCurrent detection.
Overcurrent Detected (Sticky).
No Phone Line.
This bit is sticky while off-hook if S82[3] (LCLD) = 1
hook. NLD remains sticky for 800 ms after going from off-hook to on-hook.
Intrusion Detected.
This bit is normally NOT sticky so that the user may monitor/poll for intrusion manually.
However, during dialing and during data mode, it is impossible to monitor/poll this bit.
Therefore, if the Si2400 is either dialing or in data mode, this bit is sticky. If triggered dur-
ing data mode, this bit will remain sticky for 800 ms after the Si2400 goes back on-hook.
Ring Detected (Sticky).
This bit is normally sticky, but is cleared when the Si2400 goes from on-hook to off-hook.
b
(0x00)
TEO
R/W
D5
AOC
R/W
D4
R/W
OD
D3
Rev. 1.3
NLD
R/W
D2
Function
R/W
IND
D1
b
, and non-sticky (status) while on-
R/W
RD
D0