MXL1344ACAG+ Maxim Integrated Products, MXL1344ACAG+ Datasheet - Page 8

• Manufacturer Part Number: MXL1344ACAG+
• Description: IC CABLE TERM MULTIPROTCL 24SSOP
• Manufacturer: Maxim Integrated Products
• Type: Cabler

Specifications of MXL1344ACAG+

• Number Of Terminations: 6
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 24-SSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

+5V Multiprotocol, Software-Selectable
Cable Terminator
The MXL1344A enters no-cable mode when the mode
select inputs, M0, M1, and M2 are connected HIGH or
left unconnected. In no-cable mode, all six termination
networks are placed in V.11 mode, with S1 closed and
S2 open (Figure 4).
Older multiprotocol interface termination circuits have
been constructed using expensive relays with discrete
resistors, custom cables with built-in termination, or
complex circuit-board configurations to route signals to
Figure 6. Typical V.11 Interface
Figure 7. V.11 Termination and Internal Resistance Networks
8
_______________________________________________________________________________________
GENERATOR
Applications Information
C
A
B
INTERCONNECTING
A′
B′
C′
BALANCED
CABLE
S1
R1
52Ω
R2
52Ω
TERMINATION
A′
B′
C′
100Ω
S2
CABLE
MIN
No-Cable Mode
MXL1344A
LOAD
127Ω
R3
RECEIVER
A
B
GND
S3
the correct termination. The MXL1344A provides a sim-
ple solution to this termination problem. All required ter-
mination configurations are easily cable- or software-
selectable using the four mode-control input pins M0,
M1, M2, and DCE/DTE.
The MXL1344A terminator is designed to form a com-
plete +5V cable- or software-selectable multiprotocol
DCE/DTE interface port when used with the MXL1543
and MXL1544/MAX3175 differential driver/receivers.
The MXL1344A terminator is designed to use the V
power generated by the MXL1543’s charge pump and
will meet all data sheet specifications when connected
as illustrated in Figure 5. The mode-selection tables of
all three devices are identical, allowing the M0, M1, M2,
and DCE/DTE pins of each device to be connected to a
single 4-wire control bus. The MXL1543 and MXL1544/
MAX3175 provide internal pullups for the four lines,
forcing them to the logic high state if they are not
grounded. This allows interface-mode configuration by
simply strapping the appropriate pins to ground in the
interconnect cable.
In Figure 5, M1, M2 and DCE/DTE are shorted to the
cable ground, forcing logic LOW on these control lines.
Input M0 is left floating and will be pulled HIGH by
internal pullups on the MXL1543 and MXL1544/
R8
5kΩ
Using the MXL1344A in a Multiprotocol
30kΩ
30kΩ
R5
R4
10kΩ
10kΩ
R6
R7
RECEIVER
MXL1543
Serial Interface
EE