MCZ33889BEGR2 Freescale Semiconductor, MCZ33889BEGR2 Datasheet - Page 34
![no-image](/images/manufacturer_photos/0/2/262/freescale_semiconductor_sml.jpg)
MCZ33889BEGR2
Manufacturer Part Number
MCZ33889BEGR2
Description
IC SYSTEM BASIS W/CAN 28-SOIC
Manufacturer
Freescale Semiconductor
Datasheet
1.MC33889DW.pdf
(60 pages)
Specifications of MCZ33889BEGR2
Applications
*
Interface
*
Voltage - Supply
*
Package / Case
28-SOIC (7.5mm Width)
Mounting Type
Surface Mount
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
condition is detected after 4 acknowledge bits are sent by the
MC33889B.
MC33889D:
by sampling the dominant pulse (recovery pulse) on S-H (S-
L), and incremented (up to 4) by sampling the recessive pulse
(detection pulses) on S-H (S-L). It is necessary to get 4
consecutive dominant samples (recovery pulse) to get to
zero. When reaching zero, the failure is recovered.
condition will not be detected by a single acknowledge bit
send by MC33889D, but requires a complete CAN message
(at least 4 dominant bits) send in dual wire mode, without
reception of any bit in single wire mode.
Tx permanent dominant detection:
permanent low state at the TX input which results in a
34
33889
FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
In application, with CAN communication, a recovery
When detection is complete, the counter is decremented
In application with real CAN communication, a recovery
In addition to the previous list, the MC33889 detects a
permanent dominant bus state. If TX is low for more than
0.75-4ms, the bus output driver is disabled. This avoids
blocking communication between other nodes of the network.
TXD is reported via the SPI (RCR register bit D1:
TXFAILURE). Tx permanent dominant recovery is done with
TX recessive for more than typ 32us.
Rx pin behavior while CAN interface is in TermVbat.
the CAN interface is in TermVbat and the SBC in normal or
standby mode. When the bus is driven into a dominant state
by another sending node, each dominant state is reported at
Rx by a low level, after a delay of T
wake up comparator on CANL and CANH, and thus operates
also in case of bus failure. This is illustrated in the following
figure.
The MC33889D is able to signal bus activity on Rx while
The bus state report is done through the CAN interface
Analog Integrated Circuit Device Data
Freescale Semiconductor
WAKE
.