CY8CKIT-017 Cypress Semiconductor Corp, CY8CKIT-017 Datasheet - Page 11

• Manufacturer Part Number: CY8CKIT-017
• Description: KIT DEV CAN/LIN EXPANSION BOARD
• Manufacturer: Cypress Semiconductor Corp
• Series: -r

Specifications of CY8CKIT-017

• Accessory Type: Expansion Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: CY8CKIT-001, CY8CKIT-030, CY3280-22X45
• Other names: 428-3108

3.1
3.2
CY8CKIT-017 CAN/LIN Expansion Board Kit Guide, Doc. # 001-57814 Rev. *B
3.
Kit Operation
Introduction
The CY8CKIT-017 CAN/LIN EBK example projects are designed to provide an example of two-way
CAN communication between two PSoC 3 CAN controller nodes on a CAN bus. There are two
example projects provided with this kit that can be downloaded into two separate PSoC 3 devices.
■
This project demonstrates the sending and receiving of CAN messages. The project sends an 8-bit
value on the CAN bus and it also receives an 8-bit value from the CAN bus.
■
This example project is exactly the same as the 'CAN_Example_1' project, except the CAN message
IDs are reversed. Therefore, this project implements a CAN node that can communicate with a
PSoC 3 that is programmed with the 'CAN_Example_1' project.
Refer to
Note Most of the information in this section describes kit operation when two CYC8KIT-001 DVK kits
and two CY8CKIT-017 EBK kits are available. If only one CY8CKIT-001 DVK kit and one CY8CKIT-
017 EBK kit are available, see
alternative ways of using this kit.
Programming PSoC 3 Device
The example projects are provided on the Start Page of PSoC Creator after the CY8CKIT-017 kit
contents have been installed. This section provides details on programming the PSoC 3 device.
To program the ‘CAN_Example_1’ project to the PSoC 3 silicon, follow these steps:
1. Place the PSoC 3 processor module on the CY8CKIT-001 DVK.
2. Power the DVK using either battery connections or a wall power unit.
3. Connect the Miniprog3 JTAG cable to the JTAG connector, both on MiniProg3 and the PSoC 3
The connections for steps 1 to 3 are shown in
Example Project 1: CAN_Example_1
Example Project 2: CAN_Example_2
processor module. Connect the MiniProg3 to a host PC USB high speed port using a USB cable.
Example Projects on page 25
Using a CAN Bus Analyzer Tool on page 16
for more information.
Figure
3-1.
for information on
11