ADG3249BRJ-REEL Analog Devices Inc, ADG3249BRJ-REEL Datasheet - Page 4

• Manufacturer Part Number: ADG3249BRJ-REEL
• Description: IC MUX/DEMUX 2X1 SOT23-8
• Manufacturer: Analog Devices Inc

Specifications of ADG3249BRJ-REEL

• Rohs Status: RoHS non-compliant
• Function: Multiplexer/Demultiplexer
• Circuit: 1 x 2:1
• On-state Resistance: 8 Ohm
• Voltage Supply Source: Single Supply
• Voltage - Supply, Single/dual (±): 2.3 V ~ 3.6 V
• Current - Supply: 0.01µA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-8

ADG3249
V
GND
V
V
I
I
I
V
R
C
C
C
I
t
t
t
t
t
Max Data Rate
Channel Jitter
I
CC
PLH
PZH
PHZ
BBM
TRANS
OZ
OL
CC
INH
INL
P
R
I
ON
X
X
IN
CC
ON
OFF
ON
, C
, t
, t
, t
PHL
PZL
PLZ
SEL
, C
EN
Positive Power Supply Voltage.
Ground (0 V) Reference.
Minimum Input Voltage for Logic 1.
Maximum Input Voltage for Logic 0.
Input Leakage Current at the Control Inputs.
OFF State Leakage Current. It is the maximum leakage current at the switch pin in the OFF state.
ON State Leakage Current. It is the maximum leakage current at the switch pin in the ON state.
Maximum Pass Voltage. The maximum pass voltage relates to the clamped output voltage of an NMOS device when
the switch input voltage is equal to the supply voltage.
Ohmic Resistance Offered by a Switch in the ON State. It is measured at a given voltage by forcing a specified
amount of current through the switch.
ON Resistance Match between Any Two Channels, i.e., R
OFF Switch Capacitance.
ON Switch Capacitance.
Control Input Capacitance. This consists of IN, SEL, and EN.
Quiescent Power Supply Current. This current represents the leakage current between the V
It is measured when all control inputs are at a logic high or low level and the switches are OFF.
Extra power supply current component for the EN control input when the input is not driven at the supplies.
Data Propagation Delay through the Switch in the ON State. Propagation delay is related to the RC time constant
R
Bus Enable Times. These are the times taken to cross the V
in response to the control signal, EN.
Bus Disable Times. These are the time taken to place the switch in the high impedance OFF state in response to the
control signal. They are measured as the time taken for the output voltage to change by V from the original
quiescent level, with reference to the logic level transition at the control input. (Refer to Figure 3 for enable
and disable times.)
On or Off Time. Measured between the 90% points of both switches when switching fom one to another.
Time taken to switch from one channel to the other, measured from 50% of the IN signal to 90% of the
OUT signal.
Maximum Rate at which Data Can Be Passed through the Switch.
Peak-to-Peak Value of the Sum of the Deterministic and Random Jitter of the Switch Channel.
ON
× C
L
, where C
L
is the load capacitance.
TERMINOLOGY
–4–
ON
T
voltage at the switch output when the switch turns on
max to R
ON
min.
CC
and ground pins.
REV. 0